Bedienungsanleitung Ariston KOT 7424 IO BI (Seite 27 von 82) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

455001

Zoom out

Zoom in

Vorherige Seite

1/82

Nächste Seite

Technical characteristics

This appliance conforms with the following

European Community Directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent

amendments;

- 89/336/EEC of 03/05/89 (Electromagnetic compatibility)

and subsequent amendments;

- 93/68/EEC of 22/07/93 and subsequent amendments;

- 2002/96/EC

The European Directive 2002/96/EC on Waste Electrical

and Electronic Equipment (WEEE), requires that old

household electrical appliances must not be disposed of

in the normal unsorted municipal waste stream. Old

appliances must be collected separately in order to optimise

the recovery and recycling of the materials they contain

and reduce the impact on human health and the

environment. The crossed out “wheeled bin” symbol on the

product reminds you of your obligation, that when you di-

spose of the appliance it must be separately collected.

Consumers should contact their local authority or retailer

for information concerning the correct disposal of their old

appliance.

Warning: If the hob is fitted above a built-in oven, the hob

and the oven must be connected to the mains separately

for safety reasons and to simplify operations when it is

necessary to pull the oven out for some reason.

Electrical connection

• The electrical safety of this appliance can only be guaranteed

if the latter is correctly and efficiently earthed, in compliance

with regulations on electrical safety. Always ensure that this

vital safety measure has been taken. If you have any doubts,

call in a qualified technician to check the electrical system

thoroughly.

• The manufacturer denies all responsibility for damage result-

ing from a system which has not been earthed correctly.

• Before powering the appliance, check whether the technical

characteristics featured on the appliance data plate corre-

spond with those of the mains electrical system.

• Check that the current load of the mains supply and of the

power sockets is suitable for the maximum power of the ap-

pliance, indicated on the appliance data plate. If in doubt,

contact a qualified professional.

Disconnect the appliance from the electricity supply before

all operations.

Connect your hob to the electrical system by means of a junc-

tion box: if the appliance is connected permanently to the mains,

an omnipolar circuit breaker, accessible if necessary, with a

minimum contact opening of 3 mm should be installed.

Valid only for models with a power supply cable

Some models are supplied with a single-phase power supply

cable, and should consequently only be connected to the single-

phase mains. Observe the wire colours, as indicated in the dia-

gram attached.

To install the cable, proceed as follows:

• unscrew the wire clamp screw and the contact screws.

• to make the desired electrical connection (see table), use the

jumpers housed inside the box. Position the power supply

cable wires according to the indications in the table.

• once the connections have been made, tighten all the terminal

screws fully.

• Fasten the supply cable in place with the clamp and close

the cover of the terminal board.

Valid only for models without a power supply cable

Some models are not fitted with a power supply cable, as the

cable should be sized according to the type of electrical connection

in use (see connection table below). To connect the cable, proceed

as follows:

• Using a screwdriver, prise on the side tabs of the terminal

board cover;

• Pull open the cover of the terminal board.

Electrical connections

Voltage,

Frequency

Fuses,

Sections

FR-AT-BE-DE-GP--

ES-IE-IL-IS-IT-LU-

RE-FI-GB-GR-PT--

SE-MA-NZ

230V-1+N~50 Hz

25 A*

2,5 mm²

FR-BE-NO

230V-2~50/60 Hz

25 A*

2,5 mm²

FR-BE-CH-DE-AT--

ES-IL-IT-NZ-PT-

MA- LU-SE-IS-NL

400V2-N~50 Hz

16 A*

1,5 mm²

FR-BE-NO

230V3~50 Hz

16 A*

1,5 mm²

230V2+2-N~50 Hz

16 A*

1,5 mm²

CY-AU-NZ-KW-MT

240V-1+N~50 Hz

25 A*

2,5 mm²

* Application of the simultaneity coefficient in accordance with

cei 60335-2-6 norm

12345

L1 L2

1 2 3 4 5

L1 L2 N

1 2 3 4 5

L1 L2 L3

1 2 3 4 5

L1 L2 N2N1

1 2 3 4

L N

1 2 3 4 5

Collegamenti elettrici Tensione Frequenza Fusibili Sezioni

FR-BE-AT-DE-GR-ES-IL-

IT-NZ-PT-GP-CH-MA-LU-

IE-FI-SE-IS-GB-NL-DK

230V - 1+N~ 50Hz

CY-MT-AU-NZ-KW

240V - 1+N~ 50Hz

25A *

2,5 mm²

FR-BE-NO

230V - 2 ~ 50Hz

BR=BRUN,BL=BLEU

BR=BRUIN, BL=BLAUW

BR=BRAUN, BL=BLAU

BR=BROWN, BL=BLUE

* Applicazione del fattore di simultaneità in conformità alla norma CEI

60335-2-6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston KOT 7424 IO BI Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info