Bedienungsanleitung Ariston LD87 (Seite 21 von 24) (Englisch, Französisch)

21858

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

ARISTON DISHWASHER - Instructions for installation and use

ISHWASHER

Safety within your home

Your dishwasher was built in accordance with the strictest international safety regulations. They protect

you and your family. Read the instructions and information contained in this manual: they will provide

you with useful hints as to installation, use and maintenance safety. To avoid nasty surprises.

1. Dispose of the packaging

material carefully (follow the

instructions on how to divide

your rubbish up provided by

your local Council)

2. After removing the packaging,

check to make sure your

appliance is intact. If in doubt,

contact a qualified

professional.

3. Your dishwasher must only be

used by adults and for washing

household dishes, according to

the instructions included in

this manual. Do not touch the

appliance with wet hands or

feet or barefoot.

4. We discourage the use of

extension leads and multiple

plugs. If the electricity supply

wire is not long enough, then

have it replaced with one of

the correct length and

remember that it should be

free of bends or dangerous

kinks.

5. If the appliance is not operating

properly or if maintenance

operations are necessary,

disconnect the dishwasher

from the mains power supply

(unplug it!).

6. Keep children away from the

dishwasher when it is open and

keep detergents out of their

reach.

7. Your dishwasher is not to be

installed outdoors, not even if

the area is covered by a roof:

it is extremely dangerous to

leave it exposed to rain and

thunderstorms.

8. Do not touch the heating

element during or straight after

a wash cycle.

9. Do not lean or sit on the door

when it is open, as this could

overturn the dishwasher.

10. If the appliance malfunctions,

turn off the water inlet tap and

disconnect the plug from the

wall socket. Then try

consulting the section entitled

"I you have a problem, read

this". If you cannot resolve the

problem, then call the service

centre.

If you have a problem, read this

Your dishwasher may not work or not function properly. In many cases, these are problems which can be

solved without having to call for a technician. Before calling the service centre, always check the points

below.

The dishwasher won't start

■ Is the water supply tap turned

on?

■ Is the water supply tap

connected to the hose properly?

■ Has the water in your home

been cut off?

■ Is the pressure of the water

supply sufficient?

■ Is the hose bent?

■ Is the filter on the water supply

hose blocked?

■ Is the dishwasher door open?

The dishes are not clean.

■ Have you put the right amount

of detergent into the dispenser?

■ Is the wash cycle suitable for

the dishes you have placed

inside the appliance?

■ Are the filter and microfilter

clean?

■ Can the sprayer arms turn

freely?

The dishwasher won't

drain.

■ Is the drain hose bent?

Limescale deposits or a

white film form on the

dishes.

■ Is the lid on the salt container

closed properly?

■ Is the rinse aid dosage correct?

Error messages.

Your dishwasher is equipped with

a safety system which is able to

detect any operating anomalies.

These anomalies are reported by

one or two wash cycle indicator

lights "E" flashing rapidly. Take a

note of which lights are flashing,

turn the appliance off and call for

technical assistance.

Tap off alarm

If you have forgotten to turn the

water tap on, your appliance will

remind you of this by sounding a

few short beeps for a few minutes.

Turn the tap on and your appliance

will start up again after a few

minutes. Were you to be absent

when these beeps are sounded, the

appliance will be blocked automati-

cally and wash cycle 4 and 5

indicator lights (quick wash and

soak) will flash rapidly. Turn the

appliance off at the ON-OFF but-

ton, turn on the water tap and wait

approximately 20 seconds before

turning the appliance back on, then

repeat the programming operations

and start the appliance by pressing

the Start button.

Clogged filter alarm

If the appliance is blocked and

wash cycle 3 and 5 indicator lights

(eco and soak) flash rapidly, this

means the filter is clogged by large

particles of food residue. Turn the

appliance off, clean the filter

thoroughly and reposition it in its

seat as illustrated on page 10. Then

turn the appliance back on. Repeat

the programming operations and

start the dishwasher by pressing

the Start button.

Troubleshooting

You have checked

everything, but the

dishwasher still doesn't

work and the problem

persists?

Call an authorised service centre

near you and remember to mention:

 the type of malfunction

 the model mark (Mod.) and the

serial number (S/N.) indicated on

the rating plate located on the inner

door, to one side.

11. Once taken out of use,

appliances must be made

inoperable: cut the power

supply wire and damage the

door lock.

I only want an authorised

specialised technician with original

Ariston guaranteed spare parts

Never call upon the

services of

unauthorised

technicians and always

refuse spare parts that

are not originals.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston LD87 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info