Bedienungsanleitung Ariston LV 460 A (Seite 17 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

454514

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ARISTON DISHWASHER - Instructions for installation and use

ISHWASHER

You have loaded your dishes and you now have

to set the wash cycle. It takes just one minute

to learn how

Starting the dishwasher

Make sure the

wash cycle has

ended before

removing the

dishes!

If opening the door

soon after the end

of the

programme,or

during it, stand

away from the

Dishwasher, to

avoid possible

injury from hot

steam.

You've left out a dish?

Well, it happens to everyone.

Interrupt the wash cycle by

pressing the ON-OFF button, insert

the dish you had forgotten and

press the ON-OFF button again.

The cycle will start up from where

you interrupted it.

There's been a power

failure? Have you

opened the dishwasher

door?

The wash cycle stops and then

restarts when the electricity comes

back on or when you close the door.

Everything is under control!

You can modify

the wash cycle in

progress, if it

has only just

started.

Ready, steady, go!

First of all.

After performing all the operations

described in the previous

paragraphs, turn the water tap on

completely and press ON-OFF

button "A": you will hear a short

beep and indicator light "B" lights

up. Now the appliance is on and

ready to be programmed.

Selecting the wash

cycle.

To select the wash cycle, turn knob

"D" clockwise until the reference

notch on the knob corresponds with

the number or symbol for the cycle

you wish to set (have a look at the

wash cycle table on page 17). A

short beep will indicate the start of

the wash cycle and indicator light

"E" corresponding to the cycle

starting phase will light up.

The dishwasher keeps

you informed.

Your dishwasher is fitted with

indicator lights (E) which light up

to indicate the cycle phase under

way.

Here are the symbols correspond-

ing to each cycle phase:

pre-wash, wash, rinses, drying.

At all times, your dishwasher tells

you which cycle phase is under

way.

Modifying a wash cycle

in progress.

But if you have chosen the wrong

cycle, not to worry! You can modify

the wash cycle in progress, if it has

only just started. Turn the knob

anti-clockwise until it reaches the

Reset position and, after a few

seconds, you will hear 4 beeps and

indicator light "E" will turn off. This

is to inform you that all the settings

have been cancelled. You are now

free to re-set the correct wash

cycle.

Finished?

The end of the wash cycle is

indicated by two short beeps and

the flashing of the drying phase

indicator light.

Turn the knob anti-clockwise to

Reset in order to reset all the

settings.

Turn the appliance off to cut off

the electricity supply.

Turn off the water tap.

Wait a few minutes before unload-

ing the dishes: they are very hot! If

you wait a little while, they dry

better thanks to the steam.

Empty the lower rack first.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston LV 460 A Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info