Bedienungsanleitung Ariston LVO 680 DUO (Seite 17 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

454522

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ARISTON DISHWASHER - Instructions for installation and use

ISHWASHER

First of all.

Turn on the water tap completely

and set knob "A" to "ON": you will

hear a short beep. The display turns

on and 3 dashes appear:these indi-

cate that the dishwasher is awaiting

instructions.

Selecting the wash

cycle.

Turn knob "M" until the reference

notch on the knob corresponds with

the number or symbol for the cycle

you wish to set (have a look at the

wash cycle table). After a few

seconds, you will hear a short beep:

the wash cycle has begun and

indicator "G" displays the symbol

corresponding to the cycle starting

phase.The counter "L" will indicate

the estimated amount of time left

until the end of the wash cycle.

Do not expect a precise countdown

as the wash cycle starts with an

estimated cycle time that is

updated as the cycle progresses and

according to a number of

parameters that affect the cycle

itself (such as water hardness, the

temperature of the water, the

degree of soil, etc.).

The dishwasher informs

you.

Your dishwasher is provided with

an indicator light (G) with 4

symbols which come on as the

appliance carries out the wash

phase indicated by the indicator

light.

These indicator lights represent the

phases corresponding to:

pre-wash, wash, rinses, drying.

At all times, your dishwasher tells

you where it is at.

Modifying a wash cycle

in progress.

But if you have chosen the wrong

cycle, not to worry! You can modify

the wash cycle in progress only if it

has only just started. Turn the knob

until it reaches the Reset position

and, after a few seconds, you will

hear 4 beeps. At this point, indicator

"G" comes off and 3 dashes appear.

This indicates that all the settings

have been cancelled. You are now

free to re-set the correct wash

cycle.

You've left out a dish?

Well, it happens to everyone. Inter-

rupt the wash cycle by setting the

knob to OFF, insert the dish you

had forgotten and then turn the ap-

pliance back on by setting the knob

to ON.

The cycle will start up from where

you interrupted it.

Finished?

The end of the wash cycle is

signalled by a double beep, and a

flashing END comes up on the

display. Bring the selector back to

the Reset position,and the 3 dashes

for programming cancellation will

appear.

Turn the appliance off to cut off

the electricity supply.

Turn off the water tap.

Wait a few minutes before unload-

ing the dishes: they are very hot! If

you wait a little while, they dry bet-

ter thanks to the steam.

Empty the lower rack first.

There's been a power

failure? Have you

opened the dishwasher

door?

The wash cycle stops and then

restarts when the electricity comes

back on or when you close the door.

Everything is under control!

You want to wash on

one rack only?

Remember to use half

the amount of detergent.

Your dishwasher also allows you

to wash half a load (choosing on

which rack), to save water and

electricity. Before setting any wash

cycle whatsoever, press button "I".

Each time the button is pressed,

you will hear a beep, and symbol

(upper rack) and symbol

(lower rack) appear on indicator

"N". Press it once more to reset the

rack selection and the dishwasher

will consequently wash on both

racks.

You have loaded your dishes and you now have

to set the wash cycle. It takes just one minute

to learn how

Starting the dishwasher

Make sure the

wash cycle has

ended before

removing the

dishes!

How to programme

extra drying

If you want your dishes to be

perfectly dry, follow the

instructions below.

Open the door, set the knob to

RESET and make any specific

settings, such as:

- upper or lower rack

- delayed start

Start the wash cycle by turning

the knob: observe symbol for

drying: it will flash for about 4

seconds, while the word "OFF"

appears on the display (extra drying

disabled).

If you press button "I" immediately,

you will hear a prolonged beep and

the word "ON" will appear on the

display: the extra drying has been

enabled.

Once you have made your

selection, shut the appliance door;

a beep will sound and the wash

cycle will either start immediately

or after the delay, wherever set.

Remember that with extra drying,

the wash cycle will last longer, to

provide you with drier dishes.

You decide when it

starts.

When you have loaded the dishes,

you can choose when to start your

dishwasher before setting the wash

cycle desired. Press button "P"and

you can delay the start of the wash

cycle by 1 to 24 hours. Press the

button once, a beep will sound and

the wording "24 h" will come up on

the display. Then, each time you

press the button a beep will sound

and the hours will decrease by one

hour until the delay is 01 h. If you

press the button once again, the

delayed start is reset and 3 dashes

appear on the display.

Once you have set the delayed start

time, select the wash cycle on the

knob: after the beep sounds, you

will see indicator light "H" flash on

the display and the countdown

begins (indicated on the display one

hour at a time). A quick look at the

indicator lights will keep you

informed of the countdown

progress at all times.

Have you changed your

mind?

During the countdown, you can

modify the delay by pressing button

"P" repeatedly without resetting

the wash cycle.

If you have changed your mind and

wish to start the wash cycle

immediately, press button "P" until

the countdown is fully reset.

Indicator light "H" will turn off and

the cycle will start at the sound of

a beep.

Ready, steady, go!

The delayed start

is also reset

automatically

should you fail to

select the wash

cycle within 15

seconds.

Ariston LVO 680 DUO Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info