Bedienungsanleitung Ariston LVZ 680 PLUS (Seite 18 von 84) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

454525

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Starting the dishwasher

1. Turn the water tap on.

2. Press the ON/OFF button: the display will light up.

3. Measure out the detergent (see below).

4. Load the racks (see Loading the racks) and shut the door.

5. Select the programme by turning the WASH CYCLE

SELECT knob in a clockwise direction: align the notch on the

knob with the number or symbol representing the desired

wash cycle.

6. Select the wash options (see below).

7. Start the cycle by pressing the START/RESET button: the

machine will emit a confirmation beep. The WASH CYCLE

PHASE indicator lights display the status of the cycle: Pre-

wash, Wash, Rinse, or Drying.

8. At the end of the cycle three short beeps will sound and

END will appear on the display. Switch off the appliance by

pressing the ON/OFF button, shut off the water tap and

unplug the appliance from the electricity socket.

9. Open the door and wait for a few minutes before removing

the crockery, in order to avoid burns. Unload the racks,

beginning with the lower level.

Demo*

If dON appears on the display, this means that the appliance

is in demonstration mode. To deactivate it, press the START/

RESET and ON/OFF buttons simultaneously: dOF should

appear on the display.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun: press and hold the START/RESET button for 4

seconds. After one long beep and three short beeps, the

WASH CYCLE PHASE indicator light will switch off. Select the

new cycle and switch the machine back on by pressing the

START/RESET button.

Adding extra crockery

Press the ON/OFF button and open the door, taking care to

avoid the escaping steam, and place the crockery inside the

dishwasher. Press the ON/OFF button again: the cycle starts

from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Loading the detergent

A successful wash also depends on the correct amount of

detergent being used, as recommended by the manufacturer.

Exceeding the recommended amount does not result in a

more effective wash and pollutes the environment.

compartment A: Washing detergent

compartment B: Pre-wash detergent

1. Open cover C by pressing button D.

2. Pour in the detergent after consulting the Wash cycle table:

 for powder detergent use compartments A and B

 for tablets, use

compartment A and the

bottom of the appliance, i.e.

when the cycle requires 1

tablet, place it in compartment

A and close the cover; when it

requires 2, place the second

tablet at the bottom of the

appliance.

3. Remove detergent residues

from the edges of the

compartment and close the

cover until it clicks.

Washing options

Delayed start

It is possible to delay the start time of the cycle for a period of

time between 1 and 24 hours.

1. Press the DELAYED START button: every time the button is

pressed, the time selected appears on the display and the

delayed start indicator light illuminates.

2. Select the wash cycle and press the START/RESET button:

after the beep sounds, the timer begins counting down.

3.Once this time is up, the indicator light switches off and the

wash cycle begins.

To adjust the delay time and select a lower period of time,

press the DELAYED START button. To cancel it, press the

button repeatedly until the wash cycle begins and the WASH

CYCLE PHASE indicator light corresponding to the start of the

cycle in progress illuminates.

Half load using the upper rack*

If there are not many dishes to be washed, a half load cycle

may be used in order to save water, electricity and detergent.

Before selecting the wash cycle press the HALF LOAD button

repeatedly: the indicator light will illuminate and the wash cycle

will take place only in the upper or the lower rack.

Remember to load the upper or lower rack only, and to reduce

the amount of detergent accordingly.

 It is better to use powder detergent in this case.

Extra drying*

To make sure that the crockery is completely dry at the end of

the cycle, press the EXTRA DRYING button before selecting

the wash cycle. A prolonged beep will sound to indicate that

this option has been selected and a short beep will sound to

indicate when it has been deselected.

If the Extra drying option is selected, the wash cycles will last

longer.

Start-up and use

* Only available in selected models.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston LVZ 680 PLUS Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info