Bedienungsanleitung Ariston Nevis (Seite 50 von 160) (Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

663711

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

50 /

WARNING:

- Before carrying out any work, make sure that the units have been disconnected from the electricity supply.

- Make sure the systems to which the appliance should be connected comply with current applicable standards.

CHECKS WITHOUT THE USE OF TOOLS OR INSTRUMENTS

Operation in Cooling mode - Visual checks on the Internal Unit

Problem Check Action

1 - Frost forms on the Internal Unit heat

exchanger.

1.A - Frost only at the bottom of the heat

exchanger: gas leak.

1.B - Frost covers the entire heat ex-

changer: the air ﬁ lter is clogged.

The room temperature is low

(< 20°C).

· Find the leak and recharge.

· Clean the air ﬁ lter.

Unplug the appliance and switch oﬀ the

dedicated switch before cleaning (risk

of electrocution).

· Check the room temp.

2 - No condensation forms. 2.A - If the Internal Unit heat exchanger

remains dry and the electricity con-

sumption is much lower than the

rated value, then there is a leak.

· Find the leak.

· Replace the heat exchanger.

3 - The compressor runs but there is

little cooling.

3.A - The External Unit heat exchanger

is clogged or covered: you do not

have a good heat exchange.

3.B - The ﬂ aps on the External Unit heat

exchanger are bent.

· Clean the External Unit heat exchanger.

· Straighten the ﬂ aps on the external

heat exchanger.

4 - The air temperature is low, but there

is little cooling.

4.A - The Internal Unit ﬁ lter is clogged.

4.B - The air recirculates in the Internal

Unit.

4.C - The machine has not been sized

correctly or is overloaded e.g.: heat

sources, overcrowding,...).

· Clean the ﬁ lter.

· Encourage the free circulation of air.

· Replace the appliance or remove the

overload.

5 - The compressor does not start. 5.A - The compressor is very hot: heat

protection.

· Wait for the temperature to drop.

6 - The appliance comes to a stop after a

few minutes of operation.

6.A - The internal unit fan is broken. · Replace the motor.

· Only use original spare parts.

TROUBLESHOOTING - electrics

Problem Check Action

1 - The appliance gives no sign of life (no

LEDs lit, no beeps sounded), not even

when you press the ON-OFF button

on the internal unit.

1.A - Check whether there has been a

power failure.

1.B - Check whether the plug is inserted

fully in the socket in the wall.

1.C - Check whether the automatic switch

has blown.

1.D - Check whether the selector has

been set to stop.

· Restore the power supply and the cor-

rect connections.

· Plug the appliance in fully.

· Reset the automatic switch.

· Set the selector to another function.

2 - The remote control does not work or

only works from a short distance.

2.A - Check whether the batteries are

low.

2.B - Check whether there are any ob-

stacles (curtains or ornaments) be-

tween the remote control and the

air conditioning unit.

2.C - Check whether the distance be-

tween the remote control and the

unit is too far.

· Replace the batteries.

· Remove all obstacles.

· Move closer to the air conditioning unit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston Nevis Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info