Bedienungsanleitung Ariston NUOS 200 SPLIT (Seite 30 von 104) (Englisch, Holländisch, Französisch, Italienisch)

566471

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

Heat pump water heater – GENERAL INFORMATION

EN 255-3 ; EN 60335-1 ; EN/IEC 60335-2-21 ; EN 60335-2-40 ; EN 55014-1 ; EN 61000-3-2 ; EN 61000-3-3 ; EN

50366.

1.5 Packaging and supplied accessories

The device consists of an external unit (heat pump) and an internal one (water heater), this could be anchored to a

wooden pallet (only 300L model), Both units are protected by polystyrene buffers and cardboard on the outside; all the

materials are recyclable and eco-compatible.

The following accessories are included:

- Shielded probe connection cable between units;

- Connection pipe for condensation water of the external unit;

- Drainage pipe for condensation water;

- Wall hole protection;

- Instruction manual and warranty documents;

- One 3/4” dielectric coupling.

- Rubber grommets and cable clips with screws.

1.6 Transport and handling

Upon delivery of the product, check that the latter has not been damaged during transport and that no signs of

damage appear on the packaging. In the event of damages, immediately notify any claims to the forwarder.

WARNING! Absolutely imperative that the external unit is handled and stored in an upright position, with the

aim of ensuring adequate provision of oil inside the cooling system and avoid damage to the compressor.

The indoor unit can be moved both vertically and horizontally.

The packaged unit can be moved by hand or with forklift trucks, taking care to respect the directions above. It is

recommended to keep the product in its original packaging until you install it in the selected area, particularly in the

case of a construction site.

After unpacking, check for accuracy and completeness of the supply. In case of non-compliance, please contact the

seller, taking care to make a communication within the law.

WARNING! Keep the packaging elements out of the reach of children, as they are potentially dangerous.

When transporting or handling the appliance after the initial start-up, observe the aforementioned indication

concerning the allowed tilt angle of the external unit, and ensure that all water has been drained from the tank. If the

original packaging missing, provide an adequate protection for the appliance to prevent any damages, for which the

manufacturer shall not be held liable.

1.7 Identification of the appliance

The main information for identifying the appliance is contained on the adhesive data plate located on the water heater

casing.

Internal unit

isuali

label

Descri

ption

model

tank capacity

serial no.

power supply voltage.

requency.

aximum absorbed power

max./min.

ressure of the refrigeration circui

tank protection

absorbed power

–

heating element mode

marks and symbols

thermal power yielded in heat pump mode

max./min.

ower in heat pump mode

type of refrigerant and charge

maximum tank pressure

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston NUOS 200 SPLIT Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info