Bedienungsanleitung Ariston PF 640 A (Seite 15 von 54) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

455052

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

Check the Seal

Once the appliance has been installed, make sure all the

connections are properly sealed, using a soapy water

solution. Never use a flame.

Electrical Connection

The cooktops fitted with a tripolar electrical supply cord are

designed to be be used with alternating current according to

the indications on the rating plate located under the cooktop.

The earthing wire can be identified by its yellow-green colour.

In the case of installation over a built-in electric oven, the

electrical connections for the cooktop and oven should be

independent, not only for safety purposes, but also to

facilitate removal of one or both in the future.

Electrical Connection for Gas Cooktop

Fit the supply cord with a standard plug for the demand rate

indicated on the rating plate or connect it directly to the

electrical mains. In the latter case, a single pole switch must

be placed between the appliance and the mains, with a

minimum opening between the contacts of 3 mm in

compliance with current safety codes (the earthing wire must

not be interrupted by the switch). The power supply cord

must be positioned so that it does not reach a temperature

in excess of 50°C above room temperature at any point.

Before making the actual connection, make sure that:

• The fuse and electrical system can withstand the load

required by the appliance;

• That the electrical supply system is equiped with an

efficient earth hook-up according to the norms and

regulations prescribed by law;

• That the plug or switch is easily accessible.

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow - Earth

Blue - Neutral

Brown - Live

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

Connect the Green & Yellow wire to the terminal marked “E”

or or coloured Green or Green & Yellow.

Connect the Brown wire to the terminal marked “L” or coloured

Red.

Connect the Blue wire to the terminal marked “N” or coloured

Black.

Adapting the Cooktop for Different Types of Gas

To adapt the cooktop to a different type of gas than that for

which it was designed, (see the sticker under the hob or on

the packaging), the burner nozzles must be changed, as

follows:

• Remove the pan supports and slide the burners out of

the cooktop.

• Unscrew the nozzles using a 7mm socket wrench and

replace them with those for the new type of gas. (See

table 1, “Burner and Nozzle Specifications”).

• Reassemble the parts following the instructions in reverse

order.

• On completing the operation, replace the old rating label

with the one showing the new type of gas; the sticker is

available from our Service Centres.

If the gas pressure is different than that prescribed, a pressure

regulator must be installed at the source, in compliance with

national standards governing the use of piped gas regulators.

Regulation of Air Supply to the Burner

The burners do not need a primary air regulator.

Minimum Regulation

• Turn the gas valve to minimum.

• Remove the knob and turn the regulator screw (positioned

either on the side of the top or inside the shaft) clockwise

until the flame becomes small but regular.

N.B.: In the case of liquid gas, the regulation screw must be

fully screwed in (clockwise).

• Make sure that, when the knob is turned rapidly high to

low, the flame does not go out.

• In the event of a malfunction on appliances with the

security device (thermocouple) when the gas supply is

set at minimum, increase the minimum supply levels using

the regulator screw.

Once the adjustment has been made, apply sealing wax, or

a suitable substitute, to the old seals on the by-pass.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston PF 640 A Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info