Bedienungsanleitung Ariston STEA-serie (Seite 46 von 68) (Deutsch, Englisch, Holländisch, Französisch)

655848

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

assembly. An expansion vessel may be installed in order to prevent this leakage.

• Activate the tap and the valve on the safety assembly every month so as to prevent

limescale from building up. Replace the safety assembly at least once every 5 years or, if

necessary, more frequently.

• The appliance and its safety assembly must be installed in a room which is not subject

to freezing conditions.

When performing maintenance work, the following should be provided:

- a free space of at least 50 cm in front of the plastic cover so that the electrical components

may be accessed;

- direct access to the safety assembly.

• For safety reasons, if away from the premises,users must turn the hydraulic and electric

circuits off, as well as drain the appliance.

 ➢Cut off the electricity supply before performing any work on the appliance.

 ➢Shut off the cold water supply at the inlet.

 ➢Open the hot water tap to draw water.

 ➢Open the emptying valve on the safety assembly and the water will ow out of the

drainage hole.

• To prevent burns from occurring, use suitable mixers which ensure that the temperature

does not exceed 50ºC at the drawing points and 60°C for the kitchen .

• Recommendations for installation in a bathroom environment:

The water heater installation in the bathroom must be adapted in accordance with national

rules and standards in force (NFC 15-100, RGIE, etc.).

 ➢The system must be tted with a switch which has an opening of 3 mm between con-

tacts. The circuit must be protected by fuses or switches which are calibrated according to

the power of the water heater.

 ➢ The electric water heater must be connected in accordance with European regu-

lations and the connections must always conform to current national legislation. The line

must be protected by a 30 mA differential switch.

 ➢The electrical connection of a xed appliance should be performed using a suitable

rigid wire with an appropriate cross-section and a green/ yellow earth wire: please consult

current national legislation relating to electrical systems (the minimum requirement will be

3 x 2.5 mm² singlephase and 4 x 2.5 mm² three-phase for a power level of up to 3000 W).

• CAUTION: the appliance MUST be earthed!

Do not use piping for an earth connection.

• If the appliance is supplied with rechargeable batteries, these must be removed before

the appliance is discarded and disposed of in a safe manner. The batteries must be remo-

ved from the support structure located in the area which can be accessed from underneath

the plastic cover.

• The manufacturer shall not be held liable for any damage caused to persons , animals or

other things , by unprofessional or improper installation, or by failure to comply with current

legislation or the instructions contained in this booklet.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston STEA-serie Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info