Bedienungsanleitung Ariston TQ 740 ES TI (Seite 13 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

455105

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

Installation Instructions for built-in

The following instructions are intended for the installer so

that the installation and maintenance procedures may be

followed in the most professional and expert manner

possible. Important: Disconnect the appliance from the

electrical supply before performing any maintenance

or regulation upkeep work.

Positioning the Cooktop

Important: this unit may be installed and used only in

permanently ventilated rooms in accordance with British

Standard Codes Of Practice: B.S. 6172 / B.S. 5440, Par.

2 and B.S. 6891 Current Editions. The following

requirements must be observed:

a) The room must be fitted with a ventilation system which

vents smoke and gases from combustion to the outside.

This must be done by means of a hood or electric

ventilator that turns on automatically each time the hood

is operated.

In a chimney stack or branched flue. Directly to the Outside

(exclusively for cooking appliances)

b) The room must also allow for the influx of the air needed

for proper combustion. The flow of air for combustion

purposes must not be less than 2 m³/h per kW of installed

capacity. The supply of said air can be effected by means

of direct influx from the outside through a duct with a

inner cross section of at least 100 cm² which must not be

able to be accidentally blocked. Those appliances which

are not fitted with a safety device to prevent the flame

from accidentally going out must have a ventilation

opening twice the size otherwise required, i.e. a minimum

of 200cm² (Fig. A). Otherwise, the room can be vented

indirectly through adjacent rooms fitted with ventilation

ducts to the outside as described above, as long as the

adjacent rooms are not shared areas, bedrooms or

present the risk of fire (Fig. B).

Detail A Adjacent Room to be

Room Vented

Examples of ventilation holes Enlarging the ventilation slot

for comburant air. between window and floor.

Fig. A Fig. B

c) Intensive and prolonged use of the appliance may ne-

cessitate supplemental ventilation, e.g. opening a window

or increasing the power of the air intake system (if

present).

d) Liquidified petroleum gases are heavier than air and, as

a result, settle downwards. Rooms in which LPG tanks

are installed must be fitted with ventilation openings to

the outside in order to allow the gas to escape in the

event of a leak. Therefore, LPG tanks, whether empty or

partially full, must not be installed or stored in rooms or

spaces below ground level (cellars, ect.). It is also a good

idea to keep only the tank currently being used in the

room, making sure that it is not near sources of heat

(ovens, fireplaces, stoves, etc.) that could raise the internal

temperature of the tank above 50°C.

Installation of Built-in Cooktops

The appliance can be installed next to furniture units which

are no taller than the top of the cooker hob. The wall in

direct contact with the back panel of the cooker must be

made of non-flammable material. During operation the

back panel of the cooker could reach a temperature of

50°C above room temperature. For proper installation of

the cooker, the following precautions must be taken:

a) If the cabinet(s) located next to the cooktop are higher

than the cooktop itself, the cabinet(s) must be installed

at least 600 mm from the edge cooktop;

b) Hoods must be installed in accordance with the

instructions contained in the installation manual for the

hoods themselves, and no less than 650 mm from the

cooktop;

c) The cabinets installed next to the hood must be located

at a height of at least 420 mm from the top, (as shown

in Fig. C).

HOOD

420

Min.

min.

650

mm. with hood

min.

700

mm. without hood

mm.

600

Min. mm.

420

Min. mm.

Fig. C

d) Should the cooktop be installed directly under a

cupboard, the latter should be at least 700 mm

(millimetres) from the top, as shown in Fig. C.

e) The dimensions of the cutout for the appliance must

be those indicated in the figure.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston TQ 740 ES TI Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info