Bedienungsanleitung Artel Polifuel 18 (Seite 5 von 36) (Englisch)

694452

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

1.0. INTRODUCTION

The Polifuel has a modern construction and design and is made out of the controlled materials of high

quality, welded with most modern technology and is approved and tested under EN 303 - 5 norm and

fulfil all special request for the connection on the installation of a central heating system.

1.1. BOILER DESCRIPTION

All local regulations, including those referring to national and European standards need to be

complied with when installing the appliance.

The boiler must not be modified unless using the tested original accessories we provide or if the

work is undertaken by our Customer Service.

Only fit original spare parts. These can be obtained from your customer service partner or directly

from ourselves. European standards need to be complied with when installing the appliance.

Regular care and cleaning of the appliance, flue gas outlets, connecting piece and flue.

CAUTION:

The flue may block if the boiler is heated again after a long period of it not being used. Before

starting the boiler, have the flue checked by a specialist (chimney sweep).

Ensure sufficient supply of fresh air in the installation room when heating. The air must be replaced

at least 0.8 times an hour through constant and reliable room venting. Fresh air may have to be

provided from outside if the windows and doors in the room where the boiler is installed are well

sealed or if this room contains other equipment, such as extractor hoods, clothes dryer, fan etc.

1.2. SAFETY PRECAUTIONS

1.3. IMPORTANT INFORMATIONS

This symbol indicates measures for protection against

accidents and warning for the user and / or exposed

persons.

Steel hot water boiler are engineered for wood pellet firing. In the boiler is installed the burner for wood

pellet firing with the automatic firing and automatic self-cleaning function which enables the reliable

operation also with the low quality wood pellets. The function of the automatic cleaning flue gas tubes

provides the unifying exchange of the heat and high and unifying level of boiler efficiency. Digital boiler

controller in a basic construction offers also the possibility of control with the additional equipment likes

lambda probe or level control of the wood pellets in the pellet tank. The pellet tank is the integral part of

the boiler. The boiler is delivered in pieces due to the easier transport into the boiler room.

The boiler and related accessories are state of the art and meet all applicable safety regulations.

The control unit, wiring chamber, el. heater, safety cut-out STB thermostat, fan, grid cleaning

mechanism, flue gas tubes cleaning mechanism and pellet supply mechanism are integrated into the

Polifuel. They are operate at a voltage of 230 V AC. Improper installation or repair can pose the danger of

life-threatening electric shock. Installation may beperformed only by appropriately qualified technicians.

Caution symbols:

Please take

careful note of

the following symbols in this Operating Manual.

Introduction, boiler description, safety precautions, important informations

Technical instructions Polifuel

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Artel Polifuel 18 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info