ARTURIA – KeyLab – USER’S MANUAL 35
Enter the values for Program Number and Bank Select LSB/MSB by clicking in their
respective fields and typing the numbers:
As an alternative, you can click the virtual knobs and drag them up or down until they
reach the desired values.
After this, when Pad 1 is pressed the KeyLab will send a program change command with
a value of 54, accompanied by a Bank LSB value of 50 and a Bank MSB value of 81.
Note: Be sure to check the documentation of the receiving device so you can enter the
correct Bank Select values.
5.7.3 Assign an Encoder to control a MIDI CC # within a limited range
The faders and encoders are assignable using the same techniques described for the
pads. Let’s give a quick example of an interesting use: setting the rate of an LFO so it
operates only within a certain range.
Looking at the picture above we see familiar information:
Knob 6 in Bank 1 has been selected, so it is shown in red. Its tab has been
selected in the window below the front panel graphic.
Its Mode is set to Control, which means it will transmit a value for a particular
MIDI Continuous Controller number (CC#) when it is turned.
