EN English
!
# 1 =
I'(
%II
1.4.2.1 Cutting disk starting
4%$
1. Start the engine
22
. Set the maximum speed of the motor using the accelerator lever. If the motor is cold, leave it at the maximum
speed for approx. 1 minute to warm up.
2. Grab the left handle of the handlebar with your left hand. With your right hand, following
Fig. 11
, move the control lever to its
top position until it is inserted into the strap with cables (.
3. Following
Fig. 11
, press the lock button ) on the strap (. Hold the button until the control lever starts to move the strap
with cables ( while moving down to the handle.
4. Then, with a slow, slow movement of your right hand, press the control lever on the right handle.
A$'
5. After starting the cutting disk, press the lever fully against the handle and hold it firmly.
"
$'#'
0B
With a new or cold engine, the engine may go out during the first few starts of the cutting disk drive. When the motor has warmed up,
this will no longer happen. If the cutting disk drive can not be started even after warming up the engine, make sure that there is no fault
per
Table 8.
1.4.2.2 Machine Start (Travel)
The travel is activated by the lever ( = in
Fig. 2
) on the left handle. Push the lever to the handle, and the machine will immediately
move forward. Once you press the lever and the machine starts moving forward, adjust your walking speed to the machine speed.
The travel clutch is a belt one, so you may press the clutch lever slowly - the machine does not move with a jerk, but smoothly.
$' &"
'
0$
1.4.2.3 Machine Stopping
To stop the machine travel, release the lever on the left handle. The machine travel will stop, but the cutting disc will continue to rotate.
The cutting disc drive will stop after you release the lever on the right handle.
The automatic brake will brake the cutting disc. Move the accelerator lever to the 4&0 or %Aposition.
$%II$$
$$%II
0$
$%IIA"'
1.4.2.4 Travel Speed Selection – AS 625 KM only
The machine features two travel speeds. A lower one CJ5 for dense, moist or tall growth, and higher one -J for thin, dry or
short growth.
&$+$
The change is made by moving the V-belt on the pulleys between the gearbox and the axle per
Fig. 14
. On the top cover of the gear
unit, there is a helpful sticker with a picture of the belt positions in the pulleys on the gearbox and the axle.
#$$%II%A
1. Following
Fig. 12
, loosen the plastic nut and lift the top gearbox cover (. Push in the direction of the arrow on the bottom of
the gearbox cover at the centre of the rear of the frame until the bottom cover ) releases and jumps from the projection in the
frame.
2. Slide the V-belt completely out of the pulley on the gearbox to the right into the slot in the frame between the pulley and the
machine frame tube.
3. Slide the V-belt forward for about 1.5 cm, and then move it to the wedge groove in the axle pulley per the selected gear. Check
visually and by touching whether the belt fits to the selected pulley groove.
4. Insert the V-belt into the groove in the gearbox pulley, corresponding to the selected gear. Make sure that the belt is seated
straight in the correct pulleys per the gear selected per
Fig. 14
. The belt must not cross!
((
The engine startup instructions are described in detail in the engine operating instructions.
10
