Wattage display
Kit contents:
1* Reax Mini mod
1* Tigon tank
1* Glass tube
2* Nichrome coils (1*1.2Ω & 1*0.4Ω preinstalled)
10* O-rings
1* Extra drip tip
1* USB cable
1* User manual
1* Warranty card
Tigon T
Super easy top fill
Child resistant
3.5ml capacity
Bottom adjustable airflow
E-liquid sealing mechanism
Coil resistance: 1.2Ω(10-12W) & 0.4Ω(23-28W)
Great vapor and flavor production
Super efficient wicking
Suitable for both MTL hits and restricted lung hits
Glass diameter: 24.5mm
T
Length (including drip tip): 52mm
T
1. Pull the top cap up, place your thumb on the top cap right on the
drop symbol.
2. Push the top cap away until the filling hole is revealed.
3.
4. Slide the top cap back into place.
5. Press the top cap down firmly to seal.
Coil installation
1. Unscrew to remove the base hardware.
2. Pull to remove the used coil.
3. Put a new coil into the chamber
4. Screw the base hardware back onto the tank.
NB: Coil can be replaced even when the tank is full.
Read this information leaflet fully before you start using this product as it
contains important information. The notes below relate to when the
device is filled with e-liquid that contains nicotine.
This product is intended for adult smokers. This product is not recommended
for non-smokers, young people under the age of 18 years, pregnant or breast
feeding women and those experiencing general ill health.
• When using a new coil , let the tank stand for 5 minutes
after filling so the cotton can be saturated with e-liquid
before use.
• Do not let the tank become completely empty
tank to avoid dry burning or damage to the coil.
Glass T
1. Unscrew to remove the top hardware.
2. Remove the used glass tube.
3.
4. Screw the top hardware into place.
Mod Sepcifications
Output mode:
1. Bypass output only (when resistance is less than 1.0Ω)
2. Optional output wattage: 8W
(when resistance is equal to or over 1.0Ω)
Recommended resistance range: 0.3-2.0Ω
Continuous firing time: 10 seconds
Firmware update: N/A
Bottom wattage display: L1 light=8W
L4 light=14W
Dimensions: 31.5*70*29.6mm
Battery type: Built-in LiPo
Battery capacity: 1600mah
Instructions
• Power on/off
Pressing the fire button 5 times within 2 seconds will turn the
device on or off. The bottom wattage lights will flash to indicate of
or on: flash L1-L6 lights once in turn and then, all lights flash twice
at same time to indicate off; flash L6-L1 lights once in turn and
then, all lights flash twice at same time to indicate on.
• V
When the device is on press the fire button, the indicator light will
indicate your device's current charge. When its current charge
capacity is above 3.8 volts the indicator light will be green. When
the charge is between 3.5 and 3.8 volts the light will be blue only
When the charge drops below 3.5 volts the light will then turn red
to remind you that it is time to charge your Reax mini.
• Set the output wattage
Press the mode button to adjust the output wattage, the bottom
wattage display will light the corresponding output power value:
8W
Note: The output wattage can only be adjusted when the
resistance of the connected coil is detected to be equal to, or
higher than 1.0Ω; when the coil resistance is less than 1.0Ω, the
output mode is automatically in bypass mode therefore cannot be
adjusted.
Protection Features
• The preset continuous fire time is 10 seconds,
after 10 seconds of continuous firing, the indicator light will flash
pink 10 times and the device will stop firing.
• Short circuit protection: When the device detects a short, it will
stop firing, and the indicator light will flash pink 3 times.
• Low voltage protection: When the battery level drops below 3.2V
the device will not function and the indicator light will flash red 15
times to remind you to charge the device.
• Overcharge protection: When the device is fully charged, it will
stop charging to prevent overcharging of your battery
• Over heat protection: When the temperature of the chip is above
75℃/167 ℉ , the indicator light will be yellow for 3 seconds and
the device will cut off.
Charging Instructions
• Charging the Reax Mini mod via Micro-USB charging port, the
maximum current can reach up to 2000mA.
• When the USB cable is attached the indicator light will flash red 3
times. While charging the indicator light will indicate the device’s
current charge status: 3.5 volts or less= red light; 3.5 to 3.8 volts=
blue light; 3.8 volts and above =green light. When the Reax Mini
is fully charged, the indicator light will flash green 20 times then
remain off. When unplug the USB cable, the indicator light will
flash green 3 times.
IMPORT
CONT
Before using nicotine containing e-liquids the user should read the
following information carefully
NICOTINE CONT
Do not use if you are allergic to nicotine or any of the other
ingredients contained within the e-liquid (see manufacturer’s label
for full details).
WARNINGS
Nicotine containing e-liquids are not recommended for:
• Non-smokers
• Y
• Pregnant or breast feeding women; as nicotine is known to cross
the placenta and to be excreted in breast milk;
• Those experiencing general ill health; such as heart disease,
stomach and duodenal ulcers, liver or kidney problems, long term
throat disease or difficulty breathing due to bronchitis,
emphysema or asthma;
• Those who have an overactive thyroid gland or have a
phaeochromocytoma (a tumour of the adrenal gland that can
affect high blood pressure);
• Those who have diabetes, as nicotine may affect your blood
sugar levels.
• Those taking the following medication;
• Theophylline (to treat breathing problems)
• Ropinirole (to treat restless leg syndrome)
• Clozapine (to treat schizophrenia)
POSSIBLE SIDE EFFECTS
If you inhale too much nicotine or use the product too much you
may experience one or more of the following effects:
• Feeling faint;
• Nausea (feeling sick)
• Headache
• Coughing
• Irritation of the mouth or throat
• Dizziness
• Stomach discomfort
• Hiccups
• Nasal congestion
• V
• Heart palpitations
• Abnormal heart rate
If you experience any of these side effects; including any possible
side effects not listed in this leaflet, discontinue using the product,
if the effect(s) continue after you stop use, consult your doctor or
healthcare professional and bring this leaflet to their attention.
Safety note:
T
your device when it is not in use. Especially when carrying
your device in your pocket, bag or purse.
Drip tip
Glass tube
Fire button
Micro USB
charging port
T
Coil
Airflow
control ring
Mode button
Indicator light
1 3 4 5 6 7
To learn more about your products and how to use,
please visit:
www.aspirecig.com
Building 3, Xinhongtai Industrial Park, 14 Jian'an Rd,
Tangwei, Fuyong Town, Bao'an District, Shenzhen, China
Tel: +86-755-81499783 Email: service@aspirecig.com
Shenzhen Eigate Technology Co., Ltd.
Manufactured By Eigate MADE IN CHINA
Reax mini Kit
USER MANUAL
