Bedienungsanleitung ASUS A5E (Seite 26 von 74) (Englisch)

51277

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

3 Getting Started

The Power-On Self Test (POST)

When you turn ON the Notebook PC, it will first run through a series of software-controlled diagnostic

tests called the Power-On Self Test (POST). The software that controls the POST is installed as a

permanent part of the Notebook PC’s architecture. The POST includes a record of the Notebook PC’s

hardware configuration, which is used to make a diagnostic check of the system. This record is created

by using the BIOS Setup program. If the POST discovers a difference between the record and the

existing hardware, it will display a message on the screen prompting you to correct the conflict by

running BIOS Setup. In most cases the record should be correct when you receive the Notebook PC.

When the test is finished, you may get a message reporting “No operating system found” if the hard

disk was not preloaded with an operating system. This indicates that the hard disk is correctly detected

and ready for the installation of a new operating system.

The S.M.A.R.T. (Self Monitoring and Reporting Technology) checks the hard disk drive during POST

and gives a warning message if the hard disk drive requires servicing. If any critical hard disk drive

warning is given during bootup, backup your data immediately and run Windows disk checking program.

To run Window’s disk checking program: (1) right-click any hard disk drive icon in “My Computer”, (2)

choose Properties, (3) click the Tools tab, (4) click Check Now, (5) select a hard disk drive, (6) select

Thorough to also check for physical damages, and (7) click Start. Third party disk utilities such as Symantec’s

Norton Disk Doctor can also perform the same functions but with greater ease and more features.

Powering ON the Notebook PC

The Notebook PC’s power-ON message appears on the screen when you turn it ON. If necessary, you may

adjust the brightness by using the hot keys. If you need to run the BIOS Setup to set or modify the system

configuration, press [F2] upon bootup to enter the BIOS Setup. If you press [Tab] during the splash

screen, standard boot information such as the BIOS version can be seen. Press [ESC] and you will be

presented with a boot menu with selections to boot from your available drives.

NOTE: Before bootup, the display panel flashes when the power is turned ON. This is

part of the Notebook PC’s test routine and is not a problem with the display.

IMPORTANT! If warnings are still given during bootup after running a software disk

checking utility, you should take your Notebook PC in for servicing. Continued use

may result in data loss.

IMPORTANT! To protect the hard disk drive, always wait at least 5 seconds after

turning OFF your Notebook PC before turning it back ON.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ASUS A5E Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ASUS A5E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info