FAULTS INDUCTION
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first by
checking the points mentioned below:
Fault
The appliance does not work and
the lights are not on.
The hob does not work.
F9 or FA appears in the display or
the appliance immediately starts
to beep when it is connected.
The hob does not work.
F99 appears in the display.
The fan switches on
spontaneously.
Message F8 appears.
After the zone has been switched
on, the zone displays continue to
flash.
The appliance cannot be switched
on.
Bringing food to the boil takes
longer than expected.
Fault codes F00 in the display.
Fault codes F01 – F11 in the
display.
Fault codes F1 - F6 in the display.
Cause
No electricity.
The appliance has been connected
incorrectly or the mains voltage is
not right.
Two buttons pressed at the same
time, the glass top is dirty or there
is an object lying on the controls.
The appliance is checking itself
after a power failure.
Overheating of the electronics in
the hob.
Unsuitable pans or no pan on the
cooking zone.
Appliance is locked.
Small pan used.
A control is defective, dirty or has
an object lying on it.
Button operated too long or too
much damp in the appliance.
Generator fault.
Solution
Check the electrical installation
(main fuse(s), connection).
Check the installation.
Operation error or clean glass top.
The fan switches itself off.
Allow the appliance to cool down.
Press the on/off button and the
indication will disappear. Start
again at a lower setting.
Use a suitable pan.
Keep the button with the key
symbol pressed for a few seconds.
Use a pan with a diameter
approximately the same as the
cooking zone.
Clean the appliance or have it
repaired. Do not place objects on
the control panel.
Clean the appliance or have it
repaired. Do not place objects on
the control panel.
Contact the the service
department.
168 169
MAINTENANCE general
– Clean the spark plugs preferably with a cloth. Do this carefully. If too
much pressure is applied, the distance from the point of the
sparkplug to the burner may change, causing the burner to ignite
poorly or not at all. The sparkplug will only operate correctly in a dry
environment. If the plug is very dirty, you may clean the point with a
tiny brush.
– Set the pan supports down vertically, without sliding them over the
glass plate. Assemble the burner parts using the guide ridges.
Brass wok burner parts
A few parts of the work burner are made from brass. It is normal for the
colour of the brass to change as a result of the high temperatures that
occur when cooking with a wok.
ATAG Shine
Atag supplies a range of cleaning agents under the name ATAG Shine.
These can be obtained via the website at www.hps.nl, where you will
also find various cleaning and operating tips.
