INSTALLATION
Installation above a combimicrowave oven, or an oven of a different brand
Saw out the ventilation opening(s), making sure that the total surface of the
holes is a minimum of 100 cm
2
. See the drawing, for example, showing
2 holes. Fit a protective plate between the oven and the hob. The plate
should be at least 10 mm thick and heat-resistant (85 °C). The space
between the underside of the hob and the protective plate must be at
least 50 mm. To protect the air flow, fit a protective panel - of the same
material as the protective plate - between the protective plate and the
hob. Ventilation is via the adjoining cupboards.
building in
min.
184 185
building in INSTALLATION
No extra modifications for ventilation need be made where there is a fixed
panel.
Ventilationprotection
The electronics in the appliance require cooling. The cool air is sucked from
behind the cupboard and blown out at the front and at the bottom in the
front of the appliance. The hob can only operate if there is sufficient
circulation of fresh air. The appliance will switch off after a short time if
there is not enough circulation. See to it that the traverse lath does not
hinder the airflow.
Plane or saw the lath oblique if necessary.
Above an oven of the ATAG brand
Recess height minimum 600 mm. Ventilation is via plinth and rear of
oven. Where there is a oven, a gap of at least 560 x 6 mm should be
made at the front. Cut out ventilation openings ‘A’ + ‘B’ (100 cm
2
). If
you use a 600 mm wide cabinet with a work surface with a thickness of
less than 50 mm, you must saw recess C on both sides of the cabinet, so
that the unit is not in contact with the cabinet. The hob may only be
combined with ATAG ovens, not with combi-microwave ovens.
min.
