Bedienungsanleitung ATAG KD80178BDN (Seite 21 von 36) (Deutsch, Englisch, Holländisch, Französisch)

675593

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Briefly confirm using the Fast-Freeze button

Fig. 2 (4)

c1 flashes in the display .

Briefly confirm using the Fast-Freeze button

Fig. 2 (4)

The child lock symbol

Fig. 2 (10)

illuminates in the

display.

c flashes in the display.

The child lock function is switched on.

If the function is to be switched off:

Briefly confirm using the Fast-Freeze button

Fig. 2 (4)

c1 flashes in the display .

Briefly confirm using the Fast-Freeze button

Fig. 2 (4)

c flashes in the display.

The child lock function is switched off.

End setting mode:

Briefly press the ON/OFF button

Fig. 2 (1)

The temperature is displayed again in the temperature

display.

5.2 Door alarm

For the fridge and freezer compartments

An audible warning sounds if the door is open for

longer than 60 seconds.

The audible warning stops automatically when the

door is closed.

5.2.1 Muting the door alarm

The audible alarm can be muted when the door is open. The

sound switch-off function is active as long as the door is left

open.

Press alarm button

Fig. 2 (7)

The door alarm is silenced.

5.3 Temperature alarm

The audible alarm sounds if the freezer temperature

is not cold enough.

The temperature display and the alarm symbol

Fig. 2 (8)

flash at the same time.

The cause of the temperature being too high may be:

warm fresh food was placed inside

too much warm ambient air flowed in when rearranging and

removing food

power failure for some time

the appliance is faulty

The audible alarm is automatically silenced, the alarm symbol

Fig. 2 (8)

goes out and the temperature display stops flashing

when the temperature is sufficiently cold again.

If the alarm status persists: (see Malfunction).

Note

Food may be spoilt if the temperature is not cold enough.

Check the quality of the food. Do not consume spoiled food.

5.3.1 Muting the temperature alarm

The audible alarm can be muted. When the temperature is

sufficiently cold again, the alarm function is active again.

Press alarm button

Fig. 2 (7)

The audible alarm is silenced.

5.4 Refrigerator compartment

The natural circulation of air in the refrigerator compartment

results in zones differing in temperature. It is coldest directly

above the vegetable drawers and at the rear wall. It is warmest

at the top front of the compartment and in the door.

5.4.1 Food refrigeration

Note

The energy consumption increases and the cooling perform-

ance decreases if the ventilation is inadequate.

Always keep the air slits of the fan free.

Store perishable food such as ready-to-serve dishes, meat

products and sausages in the coldest zone. Place butter and

preserves in the upper area and in the door (see Appliance

at a glance).

Use recyclable plastic, metal, aluminium and glass

containers and cling film for wrapping.

Always store liquids and food which is subject to odour or

taste transfer in closed containers or cover them.

Foods which give off a large amount of ethylene gas and

delicate foods, such as fruit, vegetables, salad, should

always be stored separately or wrapped so as not to reduce

the storage life; e.g. do not store tomatoes together with

kiwis or cabbage.

Use the front area of the refrigerator compartment floor only

for briefly putting down cooled products, e.g. when rear-

ranging and sorting. However do not leave cooled products

there otherwise they may be pushed back or tipped over

when the door is closed.

Do not store food too close together to enable good air

circulation.

5.4.2 Setting the temperature

The temperature depends on the following factors:

the frequency of opening the door

the room temperature of the installation location

the type, temperature and quantity of the food

Recommended temperature setting: 5 °C

An average temperature of approx. -18 °C is then established

in the freezer compartment.

The temperature can be adjusted continually. Once the 1 °C

setting is reached, the sequence starts again at 9 °C .

Call up the temperature function: Press the "+/-"

setting button

Fig. 2 (3)

The previously-set value will flash in the tempera-

ture display.

Change the temperature in 1 °C steps: Press the

"+/-" setting button

Fig. 2 (3)

until the required

temperature is indicated in the temperature

display.

Change temperature continually: hold down

setting button.

During adjustment the value flashes on the display.

The new setting is adopted approx. 5 seconds after the last

time the button was pressed and the set temperature

displayed again. The temperature in the interior gradually

adjusts to the new value.

5.4.3 Shelves

Moving or removing shelves

The shelves have stops preventing them from being uninten-

tionally pulled out.

Control

* Depending on model and options 21

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATAG KD80178BDN Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ATAG KD80178BDN

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info