Bedienungsanleitung ATAG Lydos (Seite 7 von 68) (Englisch, Holländisch)

790809

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Hybrid electric water heater – GENERAL INFORMATION

1 GENERAL INFORMATION

1.1 Description of the symbols used

In terms of installation and operation safety, the symbols described in the table below are used in order to stress the

importance of the relative risk warnings:

Symbol

Description

Failure to comply with this warning may result in injury to persons or, in some cases, death.

Failure to comply with this warning may result in serious damage to property and plants or injury to

animals.

It is mandatory to comply with the general and appliance-specific safety measures.

1.2 Field of application

This appliance is intended for hot water production for domestic use or similar, at temperatures below boiling point. The

appliance must be hydraulically connected to a domestic water supply line and to a power supply network. Exhaust

ducts may be used for the entry and discharge of processed air.

It is forbidden to use of the appliance for uses other than those specified. Any alternative use of the appliance constitutes

improper use and is prohibited; in particular, the appliance may not be used in industrial cycles and/or installed in

environments exposed to corrosive or explosive materials. The manufacturer shall not be held liable for any damage

due to faulty installation, improper use or uses deriving from behaviour that is are not reasonably predictable, and

incomplete or careless implementation of the instructions contained in this manual.

This appliance should not be operated by individuals (including children) with reduced physical or

sensory abilities, or by inexperienced or unskilled individuals, unless adequately supervised and trained

regarding use of the appliance by persons responsible for their own safety. Children must be

supervised by persons responsible for their safety so as to ensure that they do not use the appliance

as a toy.

1.3 Technical requirements and standards

Installation is the responsibility of the customer and must only be carried out by qualified personnel, in accordance with

applicable national legislation and any provisions issued by local and public health authorities, following the specific

manufacturer instructions provided in this manual.

It is the responsibility of the manufacturer to ensure the product complies with all relevant directives, laws and regulations

in force at the time the product is first placed on the market. Knowledge and compliance with the laws and technical

regulations inherent to the design, installation, operation and maintenance of the systems shall be the sole relative

responsibility of the designer, installer and end user. Any reference to laws, regulations or technical rules contained in

this manual is for information purposes only; the introduction of new provisions or modifications to existing laws will not

in any way binding on the manufacturer towards third parties. It is necessary to ensure that the power supply network

to which the product is connected complies with the EN 50 160 standard (otherwise the warranty will be void). For

France, ensure that installation complies with the NFC 15-100 standard.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATAG Lydos Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info