GB 61
how to clean by pyrolysis
How to use the pyrolysis program
Remove any accessories from the oven and wipe off any excess grime.
Check that the programmer displays normal time and that it is not flashing.
Press the program selection touch control until the "pyrolysis" pro-
gram appears.
Your oven displays the pyrolysis symbol that correspond to 1 two-hour
pyro. (non-adjustable).
You can select the two other cycles 1h45, or 1h30 non-adjustable, by
pressing the
-
or +
.
The oven cannot be used for 2h, 2h 15 or 2h 30. These times allow for
cooling down until the door is automatically unlocked.
Press the START/STOP touch control.
- The door is locked during pyrolysing (after about 2 minutes).
- You can consult the finishing time for the pyrolysis cycle by
pressing touch control . At the end of pyrolysing the symbol
remains lit until the door is automatically unlocked.
Stop the oven by pressing the START/STOP touch control.
Use a damp cloth for removing the white ash after the oven has cooled
down.
The oven is now ready for use.
Note: The pyrolysing temperature cannot be altered. During the cleaning
cycle the light is switched off. If your oven is still
not clean after pyrolysing you have delayed cleaning too long. Repeat the
pyrolysis program.
IMPORTANT :
Do not hang any cloths or towels on the oven door handle.
During the pyrolysis cycle, the front of the oven gets hotter than
during normal cooking.
Keep young children away.
How to program your pyrolysis to start
when you want
Follow the instructions given in the section entitled "How to use the pyrolysis
program", then:
Press touch control , the finishing time for the pyrolysis
program flashes and the symbol also flashes to show that this time can
be modified.
Set the time the program is due to finish by pressing the
+ or - touch controls..
example
: End of the pyrolysis program at 5h00.
When the pyrolysis program is over, press the START/STOP touch
control.
