336557
58
Zoom out
Zoom in
Vorherige Seite
1/70
Nächste Seite
GB 12
GB 13
MAINTENANCE
Stubborn stains
Stubborn stains
Stubborn marks on a stainless steel grill plate are best removed
with a solution of warm water and washing-up liquid. You can
use a cleaning agent for stainless steel to clean the frame. Always
polish in the direction of the steel structure to avoid shine spots.
Never use anything sharp like steel wool or scourers. These
scourers cause scratches in the brush structure. Scouring and
polishing will cause shine spots on the frying area (this kind of
damage is not covered by the warranty).
If the above methods do not help to remove the stains, you can
clean the grill plate with a non-scratch scouring pad, which can
be ordered online at www.hps.nl. Remember to treat the entire
area in order to avoid discolouring. Also, as a follow-up treat the
grill plate with a polish or maintenance agent for stainless steel.
Please note that over the years the surface will slightly discolour.
Never use aggressive abrasives. They leave scratches in which
dirt and lime can accumulate. But if you should use an abrasive
anyway, please polish in the direction of the finish.
ATAG supplies a range of cleaning agents under the name of
ATAG Shine. You may order these on www.hps.nl. The site also
contains several tips on cleaning and operating the appliance.
FAULTS
Fault table
In case of an electrical failure, please check all fuses and electrical
connections in your home before you contact the service
department.
Temperature limitation
When the teppan yaki has been switched on, a sensor
continuously monitors the temperature of the parts of the grill
plate. If the temperature gets too high, the power of the grill
plate is automatically reduced.
Fault table
Symptom Possible cause Solution
A slight smell is noticeable the first
few times that you use the grill
plate.
Appliance heating
up.
This is normal and the smell
will disappear after you have
used the teppan yaki a few
times. Ventilate your kitchen.
The grill plate becomes too hot
during frying and will not remain at
the set temperature.
The thermostat has
broken down.
Contact the service department.
The knobs do not show any colour. The appliance has
broken down.
Contact the service department.
58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für ATAG ty 3011 m wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info