Bedienungsanleitung ATAG VA6811NT (Seite 18 von 28) (Englisch)

557003

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

ActionPossible causesProblem

Rinse off these types of foodstuffs if not

starting the dishwasher immediately. Why not

use the Rinse & Hold programme.

Some foodstuffs, such as mustard, mayonnaise,

lemon, vinegar, salt and dressings, can mark

stainless steel if left for too long.

Spots on stainless steel or silver.

Silver and stainless steel items should not

come into contact during dishwashing.

All stainless steel can cause spots on silver if

they come into contact during dishwashing.

Aluminium can also cause spots on dishes.

Use a detergent with a bleaching agent.Lipstick and tea can be difficult to wash off.Spots left after washing.

Check that the dishes are placed securely. Spin

the spray arms to make sure they can rotate.

The dishes are not correctly placed or the

spray arms are not rotating.

Rattling sound when dishwashing.

Press and hold Start/Stop until the display

shows

(the door open symbol). This

indicates that the dishwasher is ready to start.

The Start/Stop start button has been pressed

for too short a time.

The dishwasher does not start.

Check.The door is not properly closed.

Check.A fuse/circuit breaker has been tripped.

Check.The plug is not plugged into the wall socket.

Check.The water tap is turned off.

Check.Overflow/leaks.

Turn off the water tap. Pull out the plug and

call the service division.

A whirring sound (the drainage pump) is

heard from the dishwasher and does not stop

when the power is cut with the On/Left-on

mode button.

Press and hold Start/Stop for three seconds

if you want to cancel the Delayed start option.

Check that the Delayed start option has not

been selected.

Loosen the drainage hose where it connects

to the sink unit's water trap. Check that no

debris has fastened. Is the cone-shaped part

of the pipe cut to an inner diameter of at least

14 mm?

Blocked drainage hose.Water remains in the dishwasher.

Check that the hose is free from kinks and

sharp bends.

Kink in drainage hose.

Clean the coarse and fine filters.The filters are blocked.

Clean the drainage pump. See the section

Care and cleaning.

Debris in the drainage pump.

Clean with washing-up brush and low foaming

cleaner.

Dirt around the seals and in corners.Bad odour in dishwasher.

Run a programme with a higher temperature

about once a month.

Low temperature programmes have been

selected for a prolonged period.

Activate the Long dry option.Drying power too low.The dishes are not dry enough.

Fully load the dishwasher.The dishwasher is not fully loaded.

Top up with rinse add or increase the rinse

aid dosage. See the sections Before washing

for the first time and Settings.

Rinse aid needs topping up or dosage is set

too low.

Open the door a little once the programme

has finished.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATAG VA6811NT Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ATAG VA6811NT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info