Bedienungsanleitung ATAG VA6811TT (Seite 22 von 28) (Englisch)

557005

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

INSTALLATION

519

1189

550

30-94

596

573

550

377

680-760

670

195

444

700

824 -872

133-183

[mm]

*Remove locking nuts and any coasters for an installed

height of 820-824 mm.

**Door length.

It is important that you read through and follow the instructions

and directions below. Conduct installation and connection in

accordance with the separate installation instructions.

SAFETY INSTRUCTIONS

• Connections to electricity, water and drainage must be

performed by a qualified professional.

• Always follow applicable regulations for water, drainage and

electricity.

• An incorrect or flawed installation can result in higher

consumption of energy, water and detergent, which can result

in increased costs and poor dishwashing results. In order to

minimise noise it is important that you follow the instructions.

• Take care during installation! Wear protective gloves! There

must always be two people!

• Place a watertight protective tray on the floor beneath the

dishwasher to prevent damage from any water leaks.

• Before screwing the dishwasher into place, test the dishwasher

by running the Rinse & Hold programme. Check that the

dishwasher fills with water and drains. Check also that none of

the connections leak.

WARNING!

Turn off the water supply when installing the dishwasher!

WARNING!

The plug must be disconnected or power to the socket turned

off while the work is carried out!

SETUP

• The recess and connection dimensions are included in the

separate installation instructions. Check that all dimensions are

correct before starting the installation.

• Make sure the area on which the dishwasher is to be installed

is firm. Adjust the adjustable feet so that the dishwasher is level.

Tighten the lock nuts.

DRAINAGE CONNECTION

See the separate installation instructions for all necessary

information.

This dishwasher is suitable for installing in a raised recess (to attain

an ergonomic working height). This means that the dishwasher

can be placed so that the drainage hose runs to a lower level than

the bottom of the dishwasher, such as by routing it directly to a

floor drain. The dishwasher is fitted with an integrated anti-siphon

device to prevent the machine from being emptied of water during

the wash cycle.

The drainage hose can also be connected to a connection nipple

on the sink unit's water trap. The connection nipple must have an

internal diameter of at least 14 mm.

The drainage hose may be extended by a maximum of 3 m (the

total length of the drainage hose must not exceed 4.5 m). Any

joins and connecting pipes must have an internal diameter of at

least 14 mm. However, the drainage hose should ideally be

replaced with a new hose without joins.

No part of the drainage hose may be more than 950 mm above

the bottom of the dishwasher.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATAG VA6811TT Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ATAG VA6811TT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info