Bedienungsanleitung ATAG VA7015QT (Seite 10 von 24) (Englisch)

675542

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Select an option

To select an option, press the option button until the desired option is

shown on the display. The available options vary between programmes.

Extra Dry

A higher temperature in the final rinse and a longer drying cycle

improve the drying results if you activate this option. Energy

consumption is slightly increased.

For a brief description, press and hold the button for Extra Dry.

Delayed Start

When you select Delayed Start, the dishwasher will start 1-24 hours

after you have pressed the button Start/Stop and closed the door.

1 Press the button once to activate Delayed Start. Press the button

several times – or hold it in – to set the desired number of hours.

2 Press Start/Stop and close the door. The timer counts down and

the dishwasher starts after the selected delay.

If you want to cancel the Delayed Start option, open the door and press

and hold the main power switch until the display turns off.

START

STOP

Starting the dishwasher

Press and hold Start/Stop until the display shows “Program started,

close door”. This indicates that the dishwasher is ready to start. Close

the door properly, or the dishwasher will not start.

If the dishwasher is not started or the door is not closed within 2 minutes

of the last button press, the machine switches off.

Time remaining

Once you have chosen a programme, programme mode and options,

the time the programme took when last used is displayed.

Stopping or changing a programme

If you want to change programme after starting the dishwasher, open

the door then press and hold Start/Stop for three seconds. Add more

detergent if the lid of the detergent dispenser has opened. Then choose

a new programme, press Start/Stop and close the door.

If you want to load more dishes

Open the door. The dishwasher stops automatically. Add the dishes

and close the door. After a while, the dishwasher continues the

programme.

If the dishwasher is turned off due to a

power failure

If the dishwashing programme was not finished, the interrupted

programme continues when power is restored.

NOTE!

During drying, the programme is interrupted if the power is cut or

the door is open for more than 2 minutes.

Once the programme has finished

Once the programme has finished and the door is opened "Ready"

appears on the display.

At the end of the programme one short signal will sound. Chapter

Settings describes how to change this function.

The dishwasher switches off automatically after the programme ends.

Shut off the water tap after each use.

How to get the best drying results

• Fully load the dishwasher.

• Angle dishes with hollows, such as cups, so that the rinse water

will run off. This is also important for plastic items.

• Top up with rinse aid or increase the rinse aid dosage level.

• Activate the Extra Dry option.

• Activate the High temperature setting. See the chapter Settings.

• Open the door a little once the programme has finished.

• Allow the dishes to cool before unloading the dishwasher.

Unloading the dishwasher

Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher

before unloading them.

Unload the lower basket first to avoid any water drops from the upper

basket falling onto the dishes in the lower basket.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATAG VA7015QT Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ATAG VA7015QT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info