Bedienungsanleitung ATAG VA7016SRT (Seite 18 von 24) (Englisch)

675536

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

ActionPossible causesProblem

See the section Settings.Incorrect rinse aid dosage setting.Spots or films on the dishes.

Switch all-in-one detergents or deactivate the

setting TAB and top up with salt and separate

rinse aid. See Rinse aid in the chapter Settings.

The setting TAB is activated and all-in-one

detergent with insufficient drying effect is being

used.

Top up with salt. See the section Before washing

for the first time.

Salt compartment empty.

See Water hardness in the chapter Settings.Incorrect water softener setting.

Check that the salt compartment lid is properly

tightened. Otherwise call the service department.

The water softener is leaking salt.

Wash crystal at a low temperature and with a

conservative amount of detergent. Contact the

detergent manufacturer.

Too high temperature and/or too much detergent

can cause etching on crystal. Unfortunately, this

cannot be repaired, only prevented.

Reduce the dosage. See the chapter Settings.

If you have very soft water, you may want to dilute

the rinse aid 50:50 with water.

Rinse aid dosage setting too high.The dishes have a sticky white/blue film.

Use a detergent with a bleaching agent.Lipstick and tea can be difficult to wash off.Spots left after washing.

The detergent compartment must be dry when

adding detergent.

The detergent compartment was damp when

adding detergent.

Detergent residue in the detergent compartment

after dishwashing.

Check that the dishes are not preventing the

detergent compartment from opening.

The detergent compartment has been blocked.

Check that the dishes are placed securely. Spin

the spray arms to make sure they can rotate.

The dishes are not correctly placed or the spray

arms are not rotating.

Rattling sound when dishwashing.

Run a self-cleaning programme. See

Self-cleaning in the chapter Using the

dishwasher.

The dishwasher tub, spray arms and spray pipes

need to be cleaned.

"Run Self-cleaning program" is shown on the

display.

Clean the coarse and fine filters.The filters are blocked.Water remains in the dishwasher.

Check that the filter handle is locked in the stop

position. The handle should point straight out

from the dishwasher.

The filters are not fitted correctly.

Clean the drainage pump. See the section Care

and cleaning.

Debris in the drainage pump.

Check that the hose is free from kinks and sharp

bends.

Kink in drainage hose.

Disconnect the drainage hose where it connects

to the sink unit's water trap. Check that no debris

has fastened and that the connection has an

inner diameter of at least 14 mm.

Blocked drainage hose.

Clean with washing-up brush and low foaming

cleaner.

Dirt around the seals and in corners.Bad odour in dishwasher.

Run a programme with a higher temperature

once or twice a month. Or run a self-cleaning

programme. See Self-cleaning in the chapter

Using the dishwasher.

Low temperature programmes have been

selected for a prolonged period.

Run a self-cleaning programme. See

Self-cleaning in the chapter Using the

dishwasher.

The dishwasher has not been used for a while.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATAG VA7016SRT Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ATAG VA7016SRT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info