Bedienungsanleitung ATAG VA98211TT (Seite 44 von 64) (Deutsch, Englisch)

634491

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

You can vary the temperature as shown below:

60 °C / 70 °CHeavy wash:

60 °C / 65 °CNormal wash:

60 °C / 65 °CDaily wash:

30 °C / 60 °CQuick wash:

40 °C / 50 °CDelicate wash:

50 °C / 55 °CEco wash:

55 °C / 65 °CUpper half:

55 °C / 65 °CLower half:

Long dry

A higher temperature in the final rinse and a longer drying phase

improves the drying result if you activate the Long dry option.

This causes a slight increase in energy consumption. This option

can be used with all programmes except Time program, Hygiene

wash and Rinse & Hold. This option cannot be activated if the

Time saver option is selected.

If you want a programme with Short dry, press again so that the

field under the button turns off.

Delayed start

When you select Delayed start, the dishwasher will start 1-24

hours after you press the Start/Stop button.

1 Press the button once to activate Delayed start. Press the

button several times – or hold it in – to set the desired number

of hours.

2 Press Start/Stop and the dishwasher counts down 1 hour at

a time and starts after the selected delay.

Press and hold Start/Stop for three seconds if you want to cancel

the Delayed start option.

NOTE!

Remember to press the Start/Stop button to start the

programme.

Set time

Press the option button several times – or hold it in – to set the

desired programme time for Time program. You can choose a

programme time between 30 minutes and 3 hours.

Time saver

This option shortens the programme time, but uses more energy

and water. This option can be selected with the programmes

Heavy wash, Normal wash, Daily wash, Upper half and Lower

half.

Start the dishwasher

Press and hold Start/Stop until the display shows (the door

open symbol). This indicates that the dishwasher is ready to start.

Close the door properly, otherwise the dishwasher will not start.

NOTE!

If the machine does not start within 2 minutes of the last button

press, the display returns to showing the last programme run.

Time remaining

Once you have selected a programme and options, the display

indicates how long the programme took the last time it was used.

The remaining time is updated after the water for the final rinse

has been heated.

This may differ somewhat from time to time depending on the

temperature of the water supply, the amount of dishes, the

ambient temperature and other factors.

NOTE!

During the first run of each programme, the remaining time

displayed can be slightly misleading, as the dishwasher is

estimating the time. When you run the programme a second

time, the dishwasher will calculate the remaining time based

on the previous duration of the programme.

Status light

The status light at the bottom on the dishwasher provides

information by means of 3 different colours. Adjust the status light

so that it is seen clearly by pulling out or pushing in the

transparent plastic strip.

Status light

Blue

Load more. The programme has started, but you can still load

more dishes.

Red

Do not load. You should not load more dishes (risk of poorer

dishwashing result).

Flashing red

This indicates a fault. See further in the section Troubleshooting.

Green

Unload. The dishwashing programme is finished. Standby light

for two hours.

Stopping or changing a programme

If you want to change programme after starting the dishwasher,

open the door then press and hold Start/Stop for three seconds.

Add more detergent if the lid of the detergent dispenser has

opened. Then choose a new programme, press Start/Stop and

close the door.

Do you want to add more dishes?

Open the door. The dishwasher stops automatically. Add the

dishes, close the door and the dishwasher continues the

programme.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATAG VA98211TT Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ATAG VA98211TT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info