98
The drawing shows the building-in
dimensions of the extractor hood.
The adjustable section at the top end of the
chimney allows you to set the correct
height.
Take into account the maximum
tolerances.
Drill holes in the wall.
Attach the brackets to the wall using the
four screws and plugs provided.
Remove the filters.
Place the hood in its correct location.
Adjust the position of the hood with the
4 adjusting screws on the support brackets
Fix the two additional screws in the holes
above the brackets.
6
7
8
9
10
11
12
Mark out the position for the section using
the towers.
Fix the section (A) to the ceiling and/or wall
using the four screws and plugs supplied
(see next).
Fit the exhaust duct.
Slide the slide-out part of the towers in the
lowest part. Position the chimney in the
hood.
Fix the towers to the sides of the section
with the two screws supplied.
Remove the film from the edges of the
filters and replace the filters in the extractor
hood.
Hand over the instructions for use to your
customer.
installationbuilding-in dimensions
installation
1
2
3
4
5
