GB 7
maintenance
cleaning
hood
enamelled extractor hoods
Clean the extractor hood with soap and a soft cloth. Then
rinse with clean water. Do not use aggressive cleaning
agents, such as soda. The enamel will remain attractive if you
polish it with wax from time to time.
stainless steel extractor hoods
For cleaning the stainless steel parts you can best use a mild
cleaning agent (washing-up liquid) and a damp cloth. Dry with
kitchen paper or a dry cloth.
The stainless steel regains its shine if you occasionally use a
stainless-steel care product or polish. The polish applies a
dirt-resistant layer to the stainless steel. Always clean the
stainless steel in the direction of polishing.
ATAG supplies cleaning and maintenance agents for extractor
hoods. For information on availability, please contact the
consumer department (see warranty conditions for the phone
numbers).
Never use abrasive cleaning agents (such as green scourers
or other scouring pads) or polishing cleaning agents (such as
liquid abrasives). Never use caustic agents. These can attack
the stainless steel.
GB 6
operation
switching on
introduction
Set the extraction capacity and lighting on the control panel.
Read on this page how to use the facilities.
switching on
models without motor
Press the on button (1).
The electrically powered flap is opened.
NB: do not leave the flap switched on for more than
12 hours at a time.
models with motor
Press the fan button for the desired setting (1, 2, 3).
1 is the lowest setting, 3 the highest.
The fan will be switched on at the desired setting.
switch off
models without motor
Press the off button ( ).
The electrically powered flap is closed.
models with motor
Press the off button ( ).
The fan is switched off.
switching lighting on
Press the lighting button ( ).
The lighting is switched on.
switching lighting off
Press the light switch ( ) again.
The lighting is switched off.
on button
lighting button
fan buttons
off button
