Bedienungsanleitung ATAG WS 9011 FM (Seite 13 von 13) (Deutsch, Englisch, Holländisch, Französisch)

109644

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

- 14 -

• INSTALLATION OF MODELS WITHOUT DECORATIVE

DUCTS

EXTRACTOR HOOD

- Remove the 4 screws B as shown in (Fig.9A).

- Remove both grid E on the air outlet hole and lid M as

shown in (Fig.9B).

- Connect the hood to the flexible hose (not supplied)

and the hose to the air exhaust hole previously prepared

(Fig.9C).

- Fix the lid once again by using the 4 screws previously

removed in (Fig.9A).

• OPTIONAL ACCESSORIES

This model may have decorative ducts as optional

accessories - ask your retailer for information.

Before fixing the decorative ducts, remove both the 4

screws B and lid M, as shown in (Fig.10A-B).

A sound-absorbing kit is also available (to be ordered as

an OPTIONAL accessory) in order to increase the

quietness level of the hood. The sound-absorbing layer

must be applied to the back of the decorative panel. For

fixing operations, refer to the instructions supplied with

the kit.

• INSTALLATION OF MODELS WITH DECORATIVE DUCTS

Make sure the electrical power supply is within the

measurements of the decorative connector.

Adjust the width of the support bracket of the top

connector (Fig.11C). Then fix it to the ceiling so that it is

on the same axis as the hood using screws A (Fig.11C)

adhering to the distance from the ceiling shown in

(Fig.11B). Connect flange C to the air exhaust hole using

flexible hose L (Fig.11D).

Slide the top duct into the bottom duct. Fix the bottom

duct to the hood using screws B (supplied) (Fig.11E).

Pull out the top duct as far as the bracket and fix it using

screws F (Fig.11C).

• FILTER HOOD

In order to change an EXTRACTOR HOOD into a FILTER

HOOD, remove the bracket from the package

and fix it using the 6 screws supplied - as shown in

Fig.14.

Order the filters as accessories from your retailer.

To replace the active carbon filters pull lever B outwards

as shown in (Fig.10).

USE AND MAINTENANCE

• It is recommended to operate the appliance prior to

cooking.

It is recommended to leave the appliance in operation for

15 minutes after cooking is terminated in order to com-

pletely eliminate cooking vapours and odours.

The proper function of the cooker hood is conditioned by

the regularity of the maintenance operations, in particu-

lar, the active carbon filter.

• The anti-grease filters capture the grease particles

suspended in the air, and are therefore subject to clog-

ging according to the frequency of the use of the appli-

ance.

In order to prevent fire hazard, it is recommendable to

clean the filter at a maximum of 2 months by carrying out

the following instructions:

- Remove the filters from the cooker hood and wash them

in a solution of water and neutral liquid detergent, leaving

to soak.

- Rinse thoroughly with warm water and leave to dry.

- The filters may also be washed in the dishwasher.

The aluminium panels may alter in colour after several

washes. This is not cause for customer complaint nor

replacement of panels.

• The active carbon filters purify the air that is replaced

in the environment. The filters are not washable nor re-

useable and must be replaced at maximum every four

months. The saturation of the active carbon filter de-

pends on the frequency of use of the appliance, by the

type of cooking and the regularity of cleaning the anti-

grease filters.

• Clean the fan and other surfaces of the cooker hood

regularly using a cloth moistened with denatured alcohol

or non abrasive liquid detergent.

• The illumination installation is designed for use during

cooking and not for prolonged general illumination of the

environment. Prolonged use of the illumination installa-

tion notably reduces the duration of the bulb.

COMMANDS: (Fig.12)

Push-button A = on/off lights switch

Push-button B = on/off cooker hood switch. The appli-

ance switches on at speed level 1, If the cooker hood is

on depress the push-button for 2 sec. to switch off the

cooker hood. If the cooker hood is at speed level 1 it will

not be necessary to depress the push-button to switch

the cooker hood off. Decreases the motor speed.

Display C = indicates the motor speed level selected

and activates the timer.

Push-button D = switches on the cooker hood. Increases

the motor speed. Touching the key at 3rd speed, the

intensive function runs for 10', then the appliance go

back to work at the original speed. During this function

the display blinks.

Key E = The Timer times the functions on activation for

15 minutes, after which they are switched off. The Timer

is deactivated by re-pressing Key E. When the Timer is

activated the decimal point must flash on the display.

The Timer cannot be activated if the intensive speed is

functioning.

The “clean air” function is activated by pressing key E

for 2 seconds when the appliance is switched off. This

switches the motor on for 10 minutes every hour at the

first speed. During functioning a rotary movement of the

peripheral segments must be visualised on the display.

When this time has passed the motor switches off and

the fixed letter “C” must be visualised on the display

until the motor re-starts after 50 minutes for another 10

minutes and so on. Press any key apart from the light

keys to return to normal functioning. Press key E to

deactivate the function.

• Active carbon/grease filter saturation:

- When display item C flashes, at a speed where it

alternates with the letter F (e.g. 1 and F), the grease

filters must be washed.

- When display item C flashes, at a speed where it

alternates with the letter A (e.g. 1 and A), the carbon

filters must be replaced.

After the clean filter has been positioned correctly, the

electronic memory must be reset by pressing button A

for approximately 5 seconds, until the indication F or A

shown on the display C stops flashing.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY

FOR EVENTUAL DAMAGES CAUSED BY BREACHING

THE ABOVE WARNINGS.

ATAG WS 9011 FM Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info