GB 3
operation
switching lighting on and off
Press the lighting button .
The lighting comes on.
Press the button again and the lighting goes out.
switching on the fan
Press the , or button.
The extractor hood comes on at the setting selected. The
on/off light on the right next to the buttons comes on.
adjusting the extractor capacity
Press a button with a higher or lower value.
intensive setting
Press the button.
switching off the fan
Press again the button you pressed.
The extractor hood switches off and the on/off light goes out.
GB 2
for your safety
please note
This appliance should be connected by a
registered fitter. Damage arising from incorrect
connection or incorrect fitting is not covered by
the guarantee.
Disconnect the appliance before starting with
cleaning or reparation. It is recommended that
you do this by removing the plug from the
socket or by setting the isolation switch to zero.
Never flambe under an extractor. The high
flames can cause fire. Even if the ventilator is
switched off.
When deep-frying, always keep a close watch.
If the appliance is used together with equipment
which uses gas or other fuels, then a sufficient
supply of fresh air must be ensured.
Switch the extractor hood on before starting to
cook.
Clean the appliance regularly, as shown in
'maintenance'. This minimises the chance of a
fire starting.
Switch off the electricity before replacing the
light bulbs! Only use the same sort of light bulbs
with the same Wattage.
In view of possible sharp edges on the chimney
we advise you to wear working gloves when
fitting the chimney.
