Bedienungsanleitung Ateq Quickset-X (Seite 16 von 18) (Englisch)

765260

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Pg. 16

Safety instructions for Li-Po battery use

The VT56 must be placed on a non-ammable surface during charging (ceramic tray or metal box).

Only charge the Li-Po battery WITH the specic charger provided.

If the battery begins to overheat more than 60°C (140°F), STOP CHARGING IMMEDIATELY. The battery

must NEVER exceed 60°C (140°F) during the charging process.

NEVER charge a battery pack immediately after use and while it is still hot. Let it cool down to room tem-

perature.

If you see any smoke or liquid coming out of the battery, stop charging immediately. Disconnect the bat-

tery from the charger and place the battery in an isolated area for at least 15 minutes. STOP USING THE

BATTERY, and return the device to your dealer.

Always keep a re extinguisher for electrical res within reach while charging the battery. In the unlikely

event that the Li-Po battery catches re, DO NOT use water to extinguish the re, use sand or the extin-

guisher described above.

The parts of a Li-Po battery must be neutralized out of use. The neutralization procedure must be carried

out within very strict safety parameters. You are recommended to contact a specialist in this battery

type to carry out this process. They will have the out-of-use battery collected by a specialized recycling

organization. Alternatively, contact your dealer.

Do not dispose of Li-Po batteries with household waste.

To avoid leaks or other hazards, do not store batteries above 60°C. Never leave the battery inside a car

(for example) where the temperature could be very high or in a place where the temperature might exceed

60°C. Store the battery in a dry place to avoid contact with any type of liquid. Store the battery only on a

non-ammable surface that is heat resistant and non-conductive, and away from any ammable materials

or sources.

A Li-Po battery must be stored with a minimum charge of 30%. If you store the battery completely dis-

charged, it will quickly become unusable. If it has to be stored for a long period (over 6 months), remem-

ber to recharge it regularly (to more than 30%).

If you do not follow these safety instructions, you risk causing serious damage to people or property, and

you even risk causing a re!

ATEQ accepts no responsibility in the event of damage arising as a result of non-compliance with these

safety instructions.

Since use of a Li-Po battery entails signicant re risks capable of causing serious damage to people and

property, the user agrees to accept the risks and the responsibility involved.

Since ATEQ cannot control correct use of the battery (charging, discharging, storage, etc.), it cannot be

held responsible for damage caused to people or property.

FCC STATEMENTS

Federal Communication Commission Interference Statement This equipment has been tested and found

to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one of the following

measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment

and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any

changes or modications not expressly approved by the party responsible for compliance could void the

user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference, including interference that may cause undesired operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ateq Quickset-X Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ateq Quickset-X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info