Bedienungsanleitung Atlantic Maradja (Seite 11 von 26) (Englisch, Französisch, Portugiesisch, Spanisch)

613626

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Once the setting is done, the device emits a BEEP to acknowledge the message.

If the device emits several BEEPS, this means that the device is at the range limit of the signal emitted by the

remote control. In this case, move closer to the device and direct the remote control towards the infrared cell.

Note :

The ECO setting can be adjusted to -3.5°C in relation to the COMFORT setting by pressing the ± buttons

simultaneously. If this position is not suitable, you can alter the ECO setting from -1°C to -7°C in relation to the

COMFORT setting.

When adjusting the COMFORT setting, the ECO setting is also changed.

2.6 Troubleshooting a communications problem between the device and the remote control

- The user is too far from the device

- The remote control is not pointing towards the device.

- The infrared cell of the remote control or the device is covered.

- The batteries are flat (in this case, the «battery» icon should be on) etc.

Note:

During normal use, the batteries should last for approximately two years (duration obtained using classical quality alkali

batteries).

When the batteries are low, the screen is more difficult to read (reduced screen contrast and shorter communications

distance)

3) Manual Mode

a) Set the cursor  to

To adjust the required Comfort temperature whilst the room is occupied:

b) Adjust knob  to

, the heating light V1 comes on if ambient temperature is below the required temperature.

c) Wait for a few hours until the temperature stabilizes.

d) If you are happy with the setting (use a thermometer to check if you wish), mark the position once and for all.

Otherwise, modify the setting and return to item c.

Note:

Manual mode is not used to override the programming but instead to adjust the value of the Comfort setting using the

dial.

- There is no point in setting the unit to its maximum, the room temperature will not rise any faster.

- Switch the unit off by putting the cursor or the remote control  to

- Remember to lower the temperature f you go out for several hours.

If go out for : less than 2 hours, do not touch the controls.

from 2 hours to 24 hours, set the cursor  to

then to select .

for more than 2 hours or during the summer, set the cursor  to then to select

If you have several units in the room, let them all operate at the same time, this will give a more uniform temperature

without increasing electricity consumption.

RECOMMENDATIONS FOR USE

WARNINGS

This appliance is not intended for use by young children or infirm persons without supervision. Young

children should be supervised to ansure that they do not play with the appliance, lean against the front or

insert objects or paper in it.

Do not totally or partially block the back part of the panel heater, as this may cause overheating.

If the supply cord is damaged, it must be replaced by a service agent or similarly qualified person in order

to avoid a hazard (applies to units fitted with a supply cord and plug).

Units fitted with a three core supply cord (brown, blue & black), must be directly connected to fixed wiring

by a licensed electrician.

All work on the interior of the appliance must be carried out by a licensed electrician.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Atlantic Maradja Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info