Bedienungsanleitung Atmos A25 (Seite 83 von 96) (Englisch)

810409

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

Operation and maintenance manual - EN

www.atmos.cz EN-83

40. Maintenance and cleaning of the burner

The system for burning wooden pellets is designed in such a way to require minimum maintenance.

The necessary degree of maintenance directly depends on the set power of the burner and quality of

used pellets.

CAUTION - Before starting repair or maintenance work during which you will handle

the burner always turn off the power supply with the main switch of the boiler or

disconnect to supply cable of the burner with the connector!

Regular removal of ashes:

Burning of wooden pellets leaves approximately 1 to 2 % of ashes. In practice you will gradually

find out how often the burner should be cleaned depending on the set power, intensity of heating and

quality of used fuel. Before the start of cleaning you must first shut down the burner and let the fuel

burn out, best by reducing the temperature on the control thermostat or by turning off the burner

switch on the boiler panel. The common interval of cleaning the burner mouth and boiler varies

in the range of 7 to 30 days (after burning of 300 to 1000 kg of high-quality pellets). You should

remove ashes from the burner mouth by removing the combustion chamber from the burner

mouth and knocking it out. Then remove ashes from the combustion space of the boiler and

clean the heat exchanger of the boiler (tube plate) as described in the boiler manual.

CAUTION - Always put ashes in a closed vessel. During the removal of ashes and cleaning

of the combustion chamber use means of personal protection (gloves and protective goggles).

Annual maintenance

• At least once a year you must perform a complete check, maintenance and inspection of the

burner during which the burner must be removed from the boiler.

• During this maintenance remove and wipe the photocell that senses the flame.

• Thoroughly clean the space under the combustion chamber of the burner and behind the ignition

spiral. Disassemble the inlet pipe through which pellets fall to the burner and clean it.

• Dismount the covering metal sheet of the burner mouth attached with one screw and clean the

space under it where pellets fall and burn (scrape off dust and deposits). Clean the opening

through which the photocell sees the flame.

• Knock dust out of the flexible supply hose and visually check whether it is not perforated. In such

a case repair it or replace. On that occasion check the worm of the external conveyor by inspecting

it from the bottom where pellets fall into the flexible hose. Check whether is it not strangled by

some objects, e.g. wound strings, a piece of wood, etc. that are sometimes found in pellets.

• Then, assemble and seat everything in the boiler. Tighten all the connections.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Atmos A25 Seite 83

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Atmos A25

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info