769379
16
Zoom out
Zoom in
Vorherige Seite
1/34
Nächste Seite
Atomos Ronin – User Manual Edition 2: November 2012 14
Audio
Located in the bottom left corner of the main screen you can see the area
for monitoring the audio levels, pressing here will allow you to access the
audio settings.
You can see 12 digital channels (via SDI input) and 2 analog audio
channels (via the XLR inputs). Each channel has a level meter assigned
to it. When there is active sound coming in you will see the level indicator
moving.
If the ‘R’ icon is highlighted red below the level meter these channels will
be recorded to disk (this is also indicated by the level meters background
changing to orange). If the headphone icon is highlighted this channel
pair will be output to both the headphones and the XLR outputs.
If recording analog audio via the XLR inputs the input gain can be
adjusted by pressing the + and - buttons to set a suitable level to match
the source. Since the analog input connections are line level, they cannot
be used with microphone level sources. Ronin does not supply +48 volts
phantom power for microphones. An adaptor is necessary to operate
with microphone level equipment.
Similarily, The analog output is also balanced line level XLR type. If you
wish to adjust the clipping point of the analog XLR outputs this can be
set by pressing on the Line Out Level indicator. The clipping level settings
are +15 dBu, +18 dBu, +22 dBu, and +24 dBu.
There is also a slider to control the headphone level. Press any point
along the line or slide your finger to the left or right to adjust. On the front
panel, there is also a mute button for the headphones along with a toggle
switch that allows you to select between mointoring the left/right or both
channels of each audio pair.
It is not possible to vary the gain if the signal input is from the SDI
connection because this is digital and is embedded in the signal.
You can usually adjust this from the camera, please see your camera
manual for operational details.
Audio During Playback Mode
When you enter into Playback mode on the Ronin it will only output
channels 1/2 on the headphones and XLR outputs, please bear this in
mind when you select the audio channels for recording. Also note, all
recorded audio channels will be present on the SDI output.
7. Using the Ronin
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Atomos Ronin wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info