[5] Light switch
e Off
r AUTO
When the light switch is set to AUTO, the dipped beam headlights will be switched
on and off automatically according to the outside light conditions (only on vehicles
with a light sensor).
t Side lights
u Dipped beam/main beam headlights
In fog, turn switch to dipped headlights position and then pull out to 1
st
stop
(i front fog lights) or to 2
nd
stop (o front and rear fog lights).
[13] Control lever for windscreen wipers/washer, on-board computer
and menu functions
Windscreen:
Wipers off
e Brief wipe
r Intermittent wipe: Move control A to alter the wiper delay intervals.
t Slow wiper speed
u Fast wiper speed
i Automatic wash and wipe: Pull lever towards you and hold.
Rear window (only Avant):
o Intermittent wipe: Press lever towards dashboard.
p Automatic wash and wipe: Press lever as far as it will go
towards dashboard and hold.
[6] Lever for turn signals and main beam headlights
e Right turn signals (with ignition off: right parking light on)
r Left turn signals (with ignition off: left parking light on)
t Main beam headlights
u Headlight flasher
To tilt open
Press the control briefly (in position )
to make the roof tilt open all the way.
Pull the control briefly to close the sun
roof.
You can also press or pull the control
and hold it (in position ) to make the
roof move up or down to the desired
position.
[12] Switch for sliding/tilting sun roof
The ignition must be switched on to open and
close the sunroof.
Comfort setting
Turn the control until it engages at position
e.
To open completely
Turn the control to position
r and hold it there.
To close
. Turn the control until it engages at position .
[7] Control lever
for cruise control system
Please refer to the Owner’s Manual
for operating instructions.
Controls for on-board computer
Press the top or bottom of rocker switch B repeatedly to display the various computer
functions in turn. Press and hold RESET button C to return the current display to zero.
RESET/Selector button
Press the RESET button C repeatedly to select the information supplied by the
on-board computer or to select the menu display. Use rocker switch B to highlight
a menu function (e.g. tyre pressure). Then activate the function by pressing the
RESET button C.
