501281
84
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
- Telephone Answering Machine -
84
10.4 Playing back the time and day on the answering machine
Press the
L button at any time to play back the weekday and time set on the
machine.
10.5 Switching the telephone answering machine on/off
If the answering machine is switched on, is takes the incoming call after a pre -defined
number of rings (refer to 10.6.3).
The
Y LED for the answering machine on the base station lights up when the
answering machine is switched on.
The answering machine is switched on and off by pressing the
M button.
Note: The answering machine can only record messages when there is
sufficient space available in the memory.
10.6 General settings
10.6.1 Maximum recording time
The answering machine can digitally record incoming messages up to a total time of
13 minutes. The maximum length for each incoming call is 2 minutes. If the caller
speaks for a longer period, an acoustic signal is issued and the call is disconnected. If
there is a pause in excess of 3 seconds during recording, the call is automatically
ended accompanied by an acoustic signal. When the memory capacity for incoming
messages is used up, no further messages are recorded. The caller receives a
message indicating that no messages can be left.
10.6.2 Setting the volume on the answering machine
If the volume of the answering machine is too high or low when playing back
messages or using the listening -in function, it can be adjusted to suit requirements.
Press the
T and W buttons to adjust the volume to one of 5 levels. The level
currently set is indicated in the display by L1 to L5. L1 is the lowest volume.
Correspondingly, L5 is the highest volume which can be set.
10.6.3 Delay taking the call
It is possible to set the number of times the telephone should ring before the
answering machine takes the calls. It can be set to between 2 and 7 rings. In addition,
the time-saver (charge saver) setting is available for pre-remote access functions.
Refer to Chapter 10.11.6.
1. Press the
S button for 2 seconds.
2. Press the
T and W buttons to select the number of rings (r2 to r7)or
the time-saver (tS ) function.
3. Press the
S button to confirm the entry.
84

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Audioline DECT3800 Bundle wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info