Operating Instructions
Batteries
Disposal
UNPACKING
Please read these operating instructions carefully
Under no circumstances open the unit yourself and do not try to
carry out your own repairs.
For an
The required batteries are not included in the scope of supply
will need 4 type AAA 1.5 V batteries.
Please use new
If the useful life of the batteries or the complete equipment has
expired, please dispose of these carefully in accordance with the
statutory requirements and in a manner friendly to the
environment.
Never open used batteries, short circuit them or throw them into
the fire.
The following parts will be found in the package:
1 or 2 PMR easy 007 Belt clip
Operating instructions
If you should have an
department on the Hotline number 0180 5 00 13 88.
INSTALLING THE BATTERIES
The required batteries are not included in the scope of
supply
batteries. Please use only new
with at least 1,100 mAh capacity
capacity will restrict the performance.
Unfasten the battery compartment cover on the back and
open the battery compartment.
Now insert the four batteries and check that the polarity is
correct. The wrong polarity can damage both the batteries
and the unit.
Close the battery compartment.
When the batteries become weak and need to be replaced,
the battery symbol will flash in the display
Note:
ATTACHING THE BELT CLIP
After you have fitted the batteries, y
attach the belt clip supplied.
Slide the belt clip from above onto the guide
(A) until it audibly snaps into place.
T
the upper tab (B) and slide the belt clip
upwards.
SWITCHING ON THE PMR easy 007
AUTOMATIC BATTERY SAVING MODE
CHANNEL SELECTION
T button pressed until
a signal tone sounds. The display will be illuminated for a few
seconds and all symbols in the display will be shown. After this,
the display will show the currently selected channel.
The PMR easy 007 is equipped with a device to increase the
battery life. If no transmissions take place within 10 seconds, the
unit switches automatically to battery saving mode.
The indicator flashes in the display
mode is automatically ended as soon as you press any of the
buttons.
The automatic battery saving mode does not affect the reception of
incoming transmissions.
The PMR easy 007 makes use of 8 different transmission channels,
which are approved by the European Committee for R
Communications as “Private Mobile R
In order to speak between two radio units, both units must be set
to the same channel. Choose between the 8 channels by pressing
the switch on the right-hand side up or down. The display
shows the channel currently selected.
Y
PMR channels and that are set to the same frequency
to the technical data for more information.
STANDBY
CH
CALLING OTHER PARTIES
When you want to speak to another party proceed as follows:
The PMR easy 007 units must be switched on and set to the
same channel.
Press the small button on the left-hand side once. A call
tone will ring out on the unit called for two seconds. Now wait
until the called party answers.
In order to speak yourself button. Hold the
unit about 5 cm away from y
volume. Afterwards, release the button once more. The
party called will hear a signal tone when you release the
button. This will tell the other person that you have finished
talking and are waiting for a reply
The volume of the incoming call signal depends on your volume
settings. Eight volume levels can be set using the
buttons.
Y
pressing the button. As is usual with radio equipment, only
one of the two parties can speak at any one time. Therefore,
always wait until y
button again.
CALL
TALK
TALK
TALK
Note:
TALK
TALK
RANGE OF THE AUDIOLINE PMR EASY 007
KEYPAD LOCK
Y has a range of up to 5 km. This maximum
range can be reduced by particular circumstances.
Y
conditions.
The range will be reduced if there are buildings or trees in the
way of the signal.
The range will be still further reduced in hilly areas.
T
changed, you can activate the k
For this purpose, press the volume adjustment
buttons simultaneously until a signal tone sounds. The symbol
will appear in the display and the channel selector the
volume buttons and the on / off switch are
locked.
T
buttons again until a signal tone sounds. The symbol will
disappear and the keypad will be unlocked.
Each time the unit is switched on, the keypad lock is
automatically deactivated.
Note:
INCREASING THE MAXIMUM RANGE
DISPLAY ILLUMINATION
EXTERNAL MICROPHONE / LOUDSPEAKER
SOCKET
Y
feature with which weak transmissions and unw
automatically suppressed during use.
This AUTO-SQUEL
increase the range.
Press and hold the button for more than five seconds until
a signal tone sounds. The automatic suppression will be switched
off and it will now be possible to receive even very weak signals.
T
button once more or one of the channel select buttons.
The display of your PMR easy 007 can be illuminated for 10
seconds by pressing the button.
Y
ear piece, a so-called headset. Y
for other activities.
The two connections can be found underneath a cover on the top
of the unit.
The headset is obtainable as an accessory
CARE INSTRUCTIONS
ACCESSORIES AVAILABLE
TECHNICAL DATA
If used correctly
PMR easy 007 The surface of the case can be cleaned with a
soft, dry
aggressive solvents.
Never put the unit down in a damp or dusty place. A
proximity to sources of heat such as radiators and do not expose
the unit to direct sunlight.
Headset
Channel 1: 446,00625 Channel 5: 446,05625
Channel 2: 446,01875 Channel 6: 446,06875
Channel 3: 446,03125 Channel 7: 446,08125
Channel 4: 446,04375 Channel 8: 446,09575
Sensitivity
for 12 Sinad: -119 dBm
for call signal recognition: -121 dBm
Max. signal to noise ratio at 47 dBm RF input 40 dB
Max. audio output at 10% harmonic distortion >150 mW
Squelch
Sensitivity -121 dBm
T 150 ms
T 250 ms
.
Frequencies:
Receiver:
MOBILE RADIO
Audio frequency response
at 300 Hz -3 dB
at 2500 Hz -12 dB
Signal distance bandwidth +/- 5 kHz
Channel separation 60 dB
Intermodulation suppression 60 dB
Interference suppression 60 dB
Effective output power 500 mW
Carrier frequency persistence 500 Hz
Modulation limit 2,5 kHz
Reaction time, carrier 30 ms
Audio frequency response
at 300 hz -10 dB
at 2,5 kHz 2 dB
Audio distortion 2%
Hum and noise 35 dB
T
T 30 ms
T <10 ms
Lifetime of batteries
Mixed usage ca. 20 hours
(T
18 hours standby)
Standby 72 hours
T
Transmitter:
Power supply:
T 4.2 to 6 V
DECLARATION OF CONFORMITY
WE
DECLARE UNDER OUR SOLE RESPONSIBILITY AS EU DISTRIBUTOR THA
MODEL: AUDIOLINE PMR easy 007
DESCRIPTION: Private Mobile Radio
IS IN CONFORMITY WITH THE BASIC REQUIREMENTS OF DIRECTIVE: 1999/5/EC
AUTHORISED SIGNA
Signature: ______________________
Name:
P MANAGING DIRECT
Date of issue: 03.07.2001
A copy of this declaration will be retained for 10 years after cessation of
production.
This product transmits in a non-EU-harmonised frequency band (466MHz)
and may thus only be used within Germany
AUDIOLINE GmbH
of PROMENADENSTR. 1
D-41460 NEUSS
GERMANY
MANFRED ZINNOW
SUPPLIER: AUDIOLINE GmbH, PROMENADENSTR. 1,
D-41460 NEUSS
PRODUCT PMR easy 007
English
SAFETY INFORMATION
PREPARATION
OPERATION
OPERATION
IMPORTANT INFORMATION
OPERATIONAL ELEMENTS
1 On / Off button 5 V
2 Channel switch CH 6 CALL button
3 Display illumination 7 T
4 Volume louder 8 Microphone head-
Phones connection
1
2
7
3
6
4
5
8
OPERATION
OPERATION
IMPORTANT INFORMATION IMPORTANT INFORMATION
OPERATING INSTRUCTIONS
PMR easy 007
