Bedienungsanleitung Audiosonic CD-571 (Seite 6 von 76) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

483860

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

POWER SUPPLY

If you would like, the electrical power supply can be used to save the batteries. Make

sure that the unit is unplugged from the wall outlet before inserting the batteries.

USING THE DC POWER SUPPLY

Batteries (not included)

Open the battery compartment and insert 8 R14 batteries with respect to the "+" and

"-" polarity indications in the compartment.

Important:

When replacing the batteries, make sure you dispose of the old batteries in

accordance with applicable regulations. They should be disposed of in a location

speciﬁcally designated for that purpose so they can be recycled safely and without

posing any risk for the environment. Do not burn or bury them. Incorrect use

of the batteries may result in electrolyte leakage having a corrosive eﬀect in the

compartment.

• Do not mix diﬀerent types of batteries: do not use alkaline batteries with saline batteries,

for example. only use batteries of the type recommended by the manufacturer.

• Do not mix old and new batteries when inserting new ones.

• If the unit is not to be used for an extended period of time, remove the batteries

from the unit.

• Batteries shall not be exposed to excessive heat such as sunshine, ﬁre or the like.

• Warning: excessive sound pressure from earphones and headphones can cause

hearing loss.

USING THE AC POWER SUPPLY

1. Make sure that the voltage indicated on the manufacturer's nameplate in the

battery compartment corresponds to the voltage supplied by your electrical

installation. If this is not the case, consult your dealer or service center.

2. Connect the electrical power cable the unit then plug it into the wall outlet. The

wall outlet must be located near the product and be easily accessible.

3. To turn power to the apparatus oﬀ, unplug the power supply cable from the wall

outlet.

4. To protect the unit during violent thunderstorms, unplug the power supply cable

from the wall outlet.

GENERAL OPERATION

1. Select the source by setting the FUNCTION SELECTOR to CD/MP3/USB, OFF or

RADIO.

2. Set the desired volume level using the VOLUME KNOB.

3. To turn oﬀ the unit, set the FUNCTION SELECTOR to OFF.

RADIO

• To listen to the FM radio, extend the telescopic antenna and orient it for optimum

reception. Reduce the length of the antenna if the signal is too strong (if you are

very near the transmitter, for example).

• As the unit is equipped with a built-in antenna, the telescopic antenna does not

have to be used to listen to MW stations. Move the entire unit to orient the built-in

antenna.

RADIO RECEPTION

1. Set the FUNCTION SELECTOR to RADIO.

2. Position the FREQUENCY BAND SELECTOR on the desired band: MW, FM or FM ST.

3. Turn the TUNING CONTROL to search for the desired station.

NOTE: The FM stereo indicator comes on if the FREQUENCY BAND SELECTOR is set

on FM stereo and you have tuned the radio to an FM stereo station.

4. Adjust VOLUME CONTROL for the desired volume level.

5. When you have ﬁnished listening to the radio, position the FUNCTION SELECTOR

to OFF to turn the unit oﬀ.

Instruction Manual

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Audiosonic CD-571 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info