Bedienungsanleitung Audiovox AX-700 (Seite 5 von 16) (Englisch)

678570

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

128-7133

5 of 16

unlock button a second time will cause all doors to unlock. If your trans-

mitter has a separate lock/unlock buttons, pressing the unlock button

anytime after the first unlock command will cause all the vehicle doors to

unlock.

# Headlight Illumination - Optional

WHILE THE SYSTEM IS SOUNDING

If during a triggered state, you wish to shut off the siren without disarming your

security system, simply press and release any transmitter button other than the

disarm button. This action will turn off the siren yet leave the vehicle fully armed

and protected. This feature is particularly useful if you are aware of children play-

ing near your vehicle that may accidently trigger your security system. In this case

you can cancel the siren sounding without disarming your alarm.

INTRUSION WARNING SIGNALS

This system will inform you if an intrusion attempt has occurred while you were

away from the vehicle. If an intrusion attempt has occurred, the siren will chirp 4

times and the parking lights will flash 3 times when disarming the system. Enter

the vehicle and observe the dash mounted LED to identify which zone was trig-

gered.

$ If the LED is flashing one time...pause...one time...pause...etc., then an

intrusion attempt was made to the shock sensor, or an accessory

triggering device that may have been added to the system.

% If the LED is flashing two times...pause...two times...pause...etc., then

an intrusion attempt was made to a hood or trunk pin switch that was

added to the system, or to a light activated entry point if the alarm was

installed using the voltage sensing feature.

& If the LED is flashing three times...pause...three times...pause...etc.,

then an intrusion attempt was made through one of the vehicle’s doors.

These intrusion warning indicators are stored in the system’s memory and will

only be erased when the ignition key is turned on.

VALET SWITCH

The valet switch allows you to temporarily bypass all alarm functions, eliminating

the need to hand your transmitter to parking attendants or garage mechanics.

When the system is in valet mode, all alarm functions are bypassed, however the

remote panic feature and remote door locks will remain operational. To use the

valet mode, the system must first be disarmed either by using your keychain

transmitter, or by operating the manual override sequence.

1. From the disarmed condition, turn the ignition key to the on position.

2. Press and hold the valet pushbutton switch until the dash mounted LED,

turns on. The LED will remain on as long as the system is in valet mode.

3. To return to normal operation, press and release the push button switch any

time the ignition is on.

Note: Always remember to return the system to the NON VALET mode, after

servicing, to ensure that the vehicle remains protected at all times.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Audiovox AX-700 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info