Bedienungsanleitung Audiovox Pursuit Series PRO 800 (Seite 3 von 12) (Englisch)

583761

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

128-6844

3 of 12

The Triggered LED Indicates:

Whenever the system is armed and then triggered from either entry point or any

additional sensor device, the triggered LED will flash 15 times, and

the hand held transceiver will play a melody.

Note: Upon trigger, the hand held unit can be selected to vibrate, play

a melody, or both. See details below.

Two Way Transmitter Operation:

The two way transmitter depicted in this manual operates similar to any

transmitter with the exception that it will also indicate that the vehicle acted upon

the command issued.

Locking: Press and release the Lock Icon Button on the transmitter and the unit,

providing it is within range of the vehicle, will lock the vehicle doors and report

back that the command was acted upon by breifly turning on the Lock LED and

beeping once. This lock LED will flash 1 time every 10 seconds until the Unlock

command is issued.

Press and hold for lock button for three seconds causes the unit to go into the

panic mode. See panic mode referenced later on in this manual.

Unlocking: Press and release the Unlock Icon Button on the transmitter and the

unit, providing it is within range of the vehicle, will unlock the vehicle doors and

report back that the command was acted upon by breifly turning on the Unlock

LED and beeping twice. This unlock LED will flash 1 time every 10 seconds

until the lock command is issued.

Press and hold for unlock button for three seconds causes the unit to go into

the car finder mode. See panic mode referenced later on in this manual.

Operating The Trunk Release: When the Trunk transmitter button is operated

for three seconds, if the optional trunk release option is installed, the vehicle's

trunk will open. The Trunk LED will flash 4 times.

NOTE: Must Have Electric Trunk Release.

If this button is operated two times in succession, an optional alternate device

will be activated. Check with your installation to see if either or both these

optional features are installed, and how they are operated.

The Option Button: Press and release the OPT Button on the transmitter and

the unit, providing it is within range of the device it is controling, will operate the

device. This option button can be programmed into a number of Audiovox

accessories. If the accessory is a second two way Audiovox Remote Start Unit,

perhaps installed in a second vehicle, then the vehicle will act upon the

command but only the prime transmitter for that vehicle will indicate the com-

mand was acted upon.

Toggling Between Vibrate, Chirp, or Both Chirp & Vibrate:

The two way transmitter offers the option of having Beep Tones, Vibration, or

Both Beep Tones & Vibration associated with the function responses of the

transmitter.

To toggle between these modes, press simultaneously the "F" function button

and the Unlock Icon Button. The transmitter will beep, beep & vibrate, or vibrate

only toggeling on the specific preference.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Audiovox Pursuit Series PRO 800 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info