705563
43
Zoom out
Zoom in
Vorherige Seite
1/164
Nächste Seite
43
EN
CONNECTIONS
1. The audio input/output (analogue), optical out (digital) and coaxial out
(digital) are available on the back of the unit to connect A/V amplier or
HiFi system.
2. Connect the rod antenna included in the supply to the antenna
connection and extend it to the desired length.
3. Depending on whether you wish to use the LAN connection or the WLAN
connection, connect the LAN cable (not include) for your network to the
LAN connection, or raise the WLAN antenna.
4. Unwind the mains cable to its full length. Connect the mains plug to the
mains socket. The unit is now connected and ready to use.
Be sure to connect the power cord to an AC outlet that supplies the correct
voltage. Hold the power plug when plugging it into an outlet or unplugging
it. Never pull or yank on the power cord.
Network Connection
Wired network
1. Check rst of all whether the control lamps (LINK/ACT) of your LAN
connection or your router light up.
2. Connect the LAN INPUT socket on the unit to the corresponding port on
your Router using a commercially available LAN or Ethernet cable (CAT5
or better with RJ45 connector).
3. Proceed with the operations described in the below “Getting Started”. It
is not necessary to run through the setup wizard.
4. Using a wired network provides a better performance than a wireless
connection because the attached devices connect directly to the network
and are not subject to radio frequency interference.
Wireless network
1. Check rst of all whether the control lamps (LINK/ACT) of your LAN
connection or your router light up.
2. Proceed with the operations described in the below “Getting Started”. It
is recommended to run through the setup wizard in the System Settings
section.
This unit cannot be connected to a standalone modem directly. A router or a
modem incorporated with a router has to be used.
Since there are various connection congurations, follow the specications
and instructions of your telecommunication carrier, internet service
provider, and router setting guidebook.
43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

auna-ituner-320-bt---10034063

Suche zurücksetzen

  • wie wähle ich Deutsch als Sprache des Betriebssystems aus? Eingereicht am 19-2-2022 10:51

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Auna iTuner 320 BT - 10034063 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info