800550

Austria Email EHT serie Seite 21

21
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
1
EN
21
OPERATING CONDITIONS
The tanks must be used exclusively in accordance with the conditions specied on the rating plate. The
maximum inlet pressure corresponds with the nominal pressure stated on the rating plate. Aside from
the legally approved national regulations and standards, the connecting requirements of the local power
company and waterworks, as well as the Mounting and Operating Instructions must be complied with.
The room in which the device is operated must be free of frost.
The device must be mounted at a location that may reasonably be expected, i.e. it must be possible to
access and replace the device without diculties for the purpose of necessary maintenance, repairs and
possible replacement. The hot water tank must only be connected with permanent piping. In the case of
heavily calciferous water, we recommend the upstream integration of a customary anti-liming device or a
maximum operating temperature of approx. 65 °C (position ••).
An appropriate quality (according to drinking water ordinance) of drinking water is required for proper ope-
ration. To avoid possible ingresses of particles, we recommend the upstream integration of a water lter.
Should a device, at the point of delivery, clearly display a malfunction, damage or other defect, this must
not be tted, installed or used in the system. Subsequent complaints regarding devices with an obvious
defect which have been connected and installed are expressly excluded under the warranty and guaran-
tee.
MOUNTING AND SAFETY INFORMATION
a) Important mounting information! Do not bend hang-up hook safety element due to
possible fracture. Risk of injury by falling device in the case of non-observance!
b) A wall rail for hanging up the upper fastening hook is enclosed with every device,
which is mounted to the wall using two screws and takes over the supporting functi-
on.
Two additional screwed connections must be provided on the wall (in accordance
with the dimensioned drawing with the device dimensions) for the lower wall plate of
the device; this has only a supporting function against the wall as well as against late-
ral shifting. The lower wall bracket has no supporting function and may therefore not
be subject to any excessive stress. Lifting and/or supporting the electrical storage he-
ater on the lower wall bracket is prohibited, as this strain can lead to the wall bracket
tearing o! Hot water heaters of a suspended type must not be mounted horizontally.
c) The fastening hooks and with that the hang-up dimension A can be adjusted at inter-
vals of 50 mm by repositioning the rear tank wall screws into other holes of the hook
(only for 50 – 150 litres). The attachment hook is always to be secured to the rear wall
of the tank with at least two screws.
Caution: Only xing hooks provided by the manufacturer may be used!
If the assembly height is changed, this is to be tightened to the mounting screws with a torque of 40 - 50 Nm.
d) The dimensioned device drawings and any information labels that may be enclosed must be observed during
mounting.
e) Caution: the weight of the water heater including the weight of the water lling (the rated capacity) must be
taken into account for load-related and strength-related design of the device mounting surface or selection of
the mounting location.
Special suspensions: see thin-wall and/or ceiling suspension.
f) If a water heater is provided with enclosures (covering), installed in narrow, small rooms or in suspended cei-
lings and the like, it is absolutely important to check that the connecting side of the device (water connections,
electric connecting area or heating unit) remains freely accessible and no accumulation of heat results. A free
space of 500 mm must be available for de-installation of the heating ange. A space of at least 50 mm must be
kept free above the device for hanging it up on the wall rail.
… 21 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Austria Email EHT serie wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info