Bedienungsanleitung Austria Email EKF series (Seite 33 von 36) (Deutsch, Englisch)

800546

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Id.Nr.: 123158-19

In the case of frost risk it should also be noted that not only the water in the hit water heater and hot water

pipes can freeze but also the water in all cold water pipes to the domestic water taps and to the device

itself. It is therefore advisable to drain all water-carrying taps and pipes up to the frost-protected part of

the domestic water system (house water connection point).

When the tank is placed back in operation it is absolutely essential to ensure that it is lled with water and

that the water escapes free of air bubbles from the hot water valves. In addition, as with the rst commis-

sioning, the tank and all connections must be checked for leaks.

MONITORING, MAINTENANCE AND CARE

a) During heating the expansion water must visibly drip out of the safety valve outlet. At maximum heating

(approx. 85 °C) the expansion water is approx. 3.5% of the nominal tank capacity.

The safety valve must be regularly (monthly) checked for correct operation. When lifting or turning the

safety valve test knob to the „Test“ position, water must ow unhindered from the body of the safety

valve into the outlet funnel.

Warning: The cold water inlet and parts of the tank connection mixer may become hot when doing

this. Water must not drip out of the safety valve when the hot water heater is not heating or hot water

is not being drawn o. If this occurs then either the water supply pressure is too high (install a pressure

reducer if above 5.5 bar) or the safety valve is defective. Please immediately notify your installation

expert.

b) In the case of highly calciferous water it is necessary for an expert to remove the scale deposits in the

internal tank and the freely deposited calcication in the system every one to two operating years.

Cleaning is performed through the ange opening – remove the heating ange, clean the tank and al-

ways use a new seal when installing the heating ange. The specially enamelled internal tank of the hot

water heater must not come into contact with boiler scale solvents – do not use a descaling pump.

After this, the device must be thoroughly ushed and the same initial heating procedure as with initial

commissioning must be followed.

c) To remain eligible for the provided guarantee the integrated sacricial anode must be checked by an

expert at a maximum interval of 2 operating years. When servicing the device, the cleaning and servi-

cing ange must also be opened to check for any possible intrusion of foreign bodies or other conta-

mination and remove these. The guard circuit shunt resistor under the heating element fastening screw

must not be damaged or removed during maintenance work.

d) Do not use abrasive cleaning agents or paint thinners (e.g. Nitro, Trichlor etc.) for cleaning the device.

The device is best cleaned using a damp cloth with a few drops of a liquid household cleaner.

In hospitals and other public buildings, the prevailing regulations for cleaning and disinfection must be obser-

ved.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Austria Email EKF series Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info