Bedienungsanleitung Austria Email KRU 102 (Seite 21 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

800537

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Id.Nr. 235161-13

8. CORROSION PROTECTION

The enamelled boiler is protected by a magnesium rod-type anode as standard. The magnesium rod-type anode is sacricial

and must therefore be inspected every 2 years (see DIN 4753) and replaced as necessary (2/3 of the material). The degra-

dation products of the magnesium anode can precipitate as dissolved matter in the bottom area of the tank and also be

rinsed out from the tank during the water withdrawal. For the anodes to function properly, the water requires a minimum

conductivity of 150 μS/cm.

When retrotting an external current anode, ensure that all magnesium rod-type anodes (e.g. in built-in heater) are removed

to prevent interference and malfunctions of the external current anode.

See Point 12, Par. C for details on servicing the anode.

The impressed current anode has a virtually unlimited service life. Its function must be regularly monitored via the control

lights (green, yellow, red).

Warning: If the red LED is lit, no corrosion protection is active! Corrosion protection is only guaranteed if the green LED lights

up continuously.

Should the red or yellow LED light up or ash, please inform Customer Services immediately.

The connection cable of the impressed current anode may in no case be extended or cut, because otherwise a possible

polarity reversal or malfunction of the anode may occur. In addition, it is to be ensured that a permanent power supply is

ensured.

Important: All metallic components (e.g. heaters, pipe register) must be introduced in a manner that is electrically

isolated from the tank.

A missing or incomplete corrosion protection (missing anode service for magnesium anode) leads to the exclusion of

the warranty.

9. TEMPERATURE INDICATOR, THERMOSTAT FOR FEED PUMP

When installing external thermostats, ensure that the boiler temperature cannot rise above 95°C during normal operation.

10. INITIAL STARTUP

The area in which the appliance is operated must be kept below freezing.

Initial startup and heating must be monitored by a technician.

Before rst starting up and connecting to the electrical mains, the tank must be lled with water. When rst lled the outlet

valve on the tting must be opened. The water heater is completely lled when water runs out of the outlet valve with no

air bubbles. All connections, including those made on the user side (ange, anode sleeve,…) must be checked for proper

sealing when starting up. Then check the pipelines for any leakage and remedy this as needed. As described under 2. above,

the safety group as well as the valves between cold water inlet and water heater must be checked for proper function. After

inspecting the electrical fuses (circuit breakers), turn the thermostat knob (for electric upright and horizontal water heaters)

to the desired temperature setting and check for the correct temperature shut-o.

After the tank is fully heated, the set temperature, the actual temperature of the water removed and any built in temperature

indicator must closely agree (after deducting the switching hysteresis and line losses).

As the water in the tank is heated, its volume changes.

During the heat-up cycle the resulting expansion water in the internal boiler must drip from the safety valve. This dripping is

normal and may not be defeated by increased tightening of the valves.

Check for automatic shut-o of the system and any attached electric heater insert or the boiler.

Caution: The hot water outlet pipe as well as parts of the safety tting can become hot to the touch.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Austria Email KRU 102 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info