810495
23
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
MO DUO / CLOU DUO User Instructions 20 english
5. Warnings and error messages
Alarms are displayed in yellow on the control panel. The pellet stove can continue to be used when an alarm
is indicated. Alarms are displayed in red. The pellet stove is inoperable when an error is displayed.
Warning
code,
Error code
Description
Solution
Alarm - A001
Fuel fill level low
Refill pellets;
reset the fill level indicator to "FULL".
Alarm - A002
Service due
Maintenance by a service technician is necessary.
Alarm - A003
Flue gas temperature
Flue gas temperature too high; service technician required.
Alarm - A004
Weak battery
Replace the storage battery (CR2032) of the control unit.
The battery must be replaced every 2 years as part of the
service.
Error- E002
IR
communication error
Infrared sensor malfunction;
contact service technician.
Error- E004
Communication error
Communication error between the control unit and the dis-
play;
check data cable plug connections.
Error- E101
Failed ignition
Restart.
Error- E102
Negative pressure
too low
or too high
Possible causes:
1. The automatic start process was terminated manually.
2. Supply air pipe, burner pot, flue gas outlets, flue gas fan or
flue pipe clogged.
3. Chimney stack dirty.
4. Chimney draught too strong.
Error- E107
Firebox sensor
Firebox temperature sensor cable defective;
call customer service.
Error- E108
Safety switch I01
error
RESET the safety temperature limiter (STB)!
Caution: STB can only be reset after cooling below 105°C.
Error- E109
Safety switch I02
error
1. Pellet hopper lid is open.
2. Riddling grate not closed.
3. Jumper on IO2 not correctly plugged in.
If the fault persists, contact the service technician.
Error- E110
Defective room tem-
perature sensor
Room temperature sensor defective. Replace sensor.
Contact service technician.
Error- E113
Excessive flue gas
temperature
Chimney fan and flue gas ducts are clogged;
cleaning is required.
Error- E114
Firebox temperature
too low
Possible causes:
1. Failed ignition.
(Empty the burner pot and restart the appliance).
2. The hopper is empty (refill the fuel hopper).
3. DC side of the control unit must be earthed.
((The furnace body has generated millivolts).
Error- E115
System shut down
Software must be reloaded.
Contact a service technician.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Austroflamm Clou Duo wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Austroflamm Clou Duo

Austroflamm Clou Duo Bedienungsanleitung - Deutsch - 48 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info