815458
67
Zoom out
Zoom in
Vorherige Seite
1/122
Nächste Seite
Operating manual Fireplace inserts slied flat + II EN 10 | Connection to ceramic flues
67
10 Connection to ceramic flues
The specifications given in advance in respect of mounting instructions and installation regulations re-
main valid (see distances, thermal insulation, exhaust pipe connection).
The appliances are particularly suitable for installation with ceramic flues. However the faultless work-
ing of the heating system is only guaranteed if the following points are observed:
Calculation of the ceramic flue
Use of suitable Materials
Compliance with maximum lengths of flue
Installation of a direct- or heating flue
Compliance with the necessary free area of the air grilles
The calculation of the ceramic flue must be made in compliance with the specified maximum flue
lengths nd according to the technical rules of the Stove- and Air Heating Constructors Association and
valid designs.
Characteristics for calculating the flue dimensions
Appliance type Exhaust gas mass flow [mg/s] Flue gas temperature at appli-
ance collar [°C]
Req’d Feed pressure at collar
[Pa]
65x S 7.3 / 7.7 / 6.8 283 / 298 / 317 12
75x S 8.1/7.7 313/300 12
75x39 SII 7.3 286 12
75x51 SII 13.07 252 13
80x64 S
80x64 SII
8.28/8.43 312/291 12
97x S 9.9 274/288 12
120x45 S 14.88 254 13
Maximum length of chamotte ceramic flues
The flue gas temperatures at the appliance collar are average temperatures over the duration of the
combustion.
Appliance type Flue length [m] Feed pressure at collar [Pa] Flue gas temperature down-
stream of the flues [ºC]
65x S 4 12 190
75x S 4 12 190
75x39 SII 4 12 190
75x51 SII 4 12 190
80x64 S
80x64 SII
4 12 190
97x S 4 12 190
120x45 S 4 12 190
The flue is constructed of refractory mineral materials. When setting up, attention must be paid to pro-
cessing that is impervious to heating gases. The ceramic flue support must be load-bearing and heat-
resistant. The installation base on which the heat exchanger is to be set up must be heat insulated in
analogy to the manner described in the section on Protection of the set up area.
The flue pipe connection must be connected gas-tight to the ceramic flue by means of plug-in steel
tubes. The connection of the pipes to the ceramic flue is preferably to be made with a premanufac-
tured connection block made of chamotte.
TIP
The steel tube/chamotte transition must be separate (expansion) and tight. The connecting pipes do
not need to be thermally insulated.
67

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II

Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II Bedienungsanleitung - Deutsch - 124 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info