694335
10
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
english 8 Mr. Wu
!
! !
! As soon as the stove has started, the automatic mode
will move the infeed automatically to the top, until the end
position is reached. A shut-off is not possible.
Fig. 6: control panel details
This key regulates the thermal output:
I: one LED: part load 3 kW
II: two LED: nominal heat output 6 kW
For reloading fuel please proceed as follows: Attention -
there must not be any ambers at all in the combustion
chamber! Slowly open stove door (use the delivered
mitten), place wood briquette and split off a slice of it, place
ignition aid (Fig. 4), set start position (Fig. 5) and ignite with
a lighter. Close door and press the start key.
The stove door and the ash drawer door may only be
opened to add fuel or to remove the ashes. Both have to
be closed again afterwards.
!
! !
! If the stove operates in the automatic mode, then
pressing the „UP“ or „DOWN“ key only causes one feeding
step (a few millimeters) up or down for safety reasons. This
may be helpful to readjust the briquette position.
Battery indicator
A maximum of 5 LEDs of the battery indicator shows the
condition of your stove’s batteries. If the batteries have a
charge capacity of less than 30 %, then the two bottom
LEDs blink slowly. If there is a charge load of less than
16 %, the LEDs will blink faster.
LED-Alarm
The red alarm-LED will be activated as soon as:
the top end position will not be reached despite the
permanent pressing of the “UP” key
the bottom end position will not be reached despite
the permanent pressing of the “DOWN” key
the top end posiotion will not be reached 10 h after
pressing the „START“ key in the automatic mode
Alarms can be reset by simultaneously pressing the „UP“
and „DOWN“ keys. Alternatively you can cut off the power
supply.
Beep signals
Pressing the keys is being confirmed by a flashing LED and
by a beep signal. These beep signals can be switched on or
off by pressing all four keys at the same time.
Diameter wood briquette
The standard setup of the briquette diameter for Mr. Wu is
10 cm. If you use briquettes with a diameter of < 9,5 cm,
please adjust the hexagon shaft by turning it (clockwise =
reduction of the diameter. (see fig. 7)
Fig. 7: adjusting the briquette diameter
Heating in-between seasons
If you heat the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead
to disturbances in the chimney draught, especially if
the temperatures are rising suddenly.
Chimney fire
A chimney fire may occur, due to soot and deposits
in the chimney, if improper or humid fuel is used. In
case of a chimney fire close all air inlets on the
fireplace/chimney immediately and call the fire
brigade. Please have an expert inspect your chimney
for cracks and air-tightness after the burning out of
the chimney.
Heating with external air supply
Mr. Wu can be operated with an external air supply. If the
combustion air is being ducted from outside directly to the
stove by means of an airtight conduit including shut-off
device, the stove may also be operated in residential units
with mechanical ventilation.
If the stove is being operated like this a multiple chimney
connection with other devices is not allowed.
Maintenance
To clean the glass, please use a specialised product such
as Thermohit glass cleaner. Lacquered surfaces are to be
cleaned only with a cloth (may be damp). Special cleaning
agents should also be used for stainless steel surfaces.
Only gaskets in good order ensure the proper function of
your stove!
Cleaning
The stove, flue outlets and smoke pipes should be cleaned
and inspected for deposits every year if necessary more
often, e.g. after the cleaning of the chimney. The chimney
also has to be cleaned regularly by the chimneysweeper.
Your chimneysweeper will inform you of the necessary
inspection intervals. An expert should inspect the stove
annually. The ash drawer should be emptied after approx. 3-
4 heating cycles.
battery
compartment
ash drawer
door
battery indicator
Alarm
-
LED
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Austroflamm Mr. Wu wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info