english 74
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
. “Volume”
Set the desired loudspeaker volume or switch it off altogether by tapping on the
and/or
symbols.
4.15. Manual pellet feed
When you use your pellet stove for the first time or after cleaning the screw conveyor chute, the pellet
screw conveyor is completely empty. This means that you must use the “Manual feed” function to fill the
screw conveyor before putting it into service.
Tap the screen (if it is still in idle mode) to leave idle mode. If the display is not currently in idle mode, skip
this step.
''Manual feed''
Activate manual feed by keeping the “Feed” symbol pressed. After keeping the symbol pressed for 30
seconds, manual feed is deactivated again automatically. If 30 seconds was not enough to fill the screw
conveyor, hold the symbol again. Repeat the procedure until the first pellets start dropping into the burner
bowl (this can take up to five minutes).
4.16. Checking the time to service
You must service your pellet stove on a regular basis. A service counter is integrated for this
purpose, which you can read off as follows:
Tap the screen (if it is currently in idle mode) to leave idle mode. If the display is not currently in idle
mode, skip this step.
. . ''Time to service''
The display counts down from 1200 h of operating time to 0 h, which means that the time to service
has been reached. In this case, the system displays alarm A002 on the control panel. Please
contact your dealer.
4.17. “Display cleaning” function
The control panel has a function for deactivating the display for 30 seconds. This allows you to
clean the display without triggering any functions.
Tap the screen (if it is currently in idle mode) to leave idle mode. If the display is not currently in idle
mode, skip this step.
. “Display options” “Display cleaning”
Tap the ''START'’ symbol to start the 30-second countdown
! NOTE: While the pellet stove is running, this function is deactivated.
4.18. Setting the language
To set the desired language, proceed as follows:
mode, skip this step.
control panel restarts.
