Bedienungsanleitung Avenli 17771 (Seite 4 von 21) (Deutsch, Englisch, Holländisch)

765070

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

SRP1-20-GB(V1) SRP1-20-GB(V1)

It is absolutely essential to select a suitable site for your pool BEFORE attempting to

ll it with any water. Please select a set-up site which strictly conforms to the following

guidelines:

Guide1. Ensure that the area is rm, at (no bumps or mounds of earth) and extremely level, with a grade not exceeding

3° of slope at any point in the set-up area.

Guide2. Make sure that the area you have selected to set-up the pool is completely free of sticks, stones, sharp objects or

other foreign debris.

Guide3. Select an area that is not directly underneath overhead power lines or trees. Additionally, make sure that the pool

set-up area does not contain underground utility pipes, lines, or cables or any kind.

Guide4. If a ground cloth is provided with your pool kit, its use is highly recommended. The ground cloth will help protect

the pool liner from damage due to weed growth, sharp objects, and debris.

Guide5. If at all possible, choose an open location on your property that is exposed to direct sunlight. This will help to

warm your pool.

WARNING:

Pools installed on inadequately level surfaces are subject to leaking,

forming irregularities, or collapse, which can result in property damage or serious in-

jury for those in or around the pool area!

WARNING:

Do not use sand during setup process. If it appears that there is a need

for use of a “leveling agent”, then your set-up site is likely unsuitable. FAILURE TO

OBEY THIS WARNING MAY RESULT IN SERIOUS PERSONAL INJURY.

CAUTION:

Please choose your set-up area carefully, as lawn and other desirable

vegetation underneath the ground cloth(If applicable) will die. Furthermore, try to avoid

setting the ground cloth(If applicable)in areas prone to aggressive plant and weed spe-

cies, as they may grow through the ground cloth(If applicable).

CAUTION:

The pool must be accessible to a 110 or 230-volt AC outlet protected by

a Ground Fault Circuit Interrupter (GFCI). The pool should be set no closer than 2 m. to

the power source, but no further than the length of the lter pump cord. Under no cir-

cumstances should an extension cord be used to extend the range of the connection.

+3°

Bumpy,Sloping Ground-INCORRECT

Flat,Level Ground-CORRECT

PART3-SITE SELECTION

Step3. INSTALL HORIZONTAL BEAM

PART4-SET UP THE POOL

Step1. ACCOUNT FOR ALL PARTS.

Remove all the parts from the carton(s) and place them on the ground in the location where they are to be assembled

Check each part according to “PART REFERENCE” .Make sure all the pieces to be assembled are accounted for.

IMPORTANT: Do not start assembly if any pieces are missing. For replacement pieces call the Consumer Service

telephone number in your area.

The number of persons required for installation: 2 adult at least.

Total installation time except the time for site preparation and water lling :

30 minutes for size 10’ x 6.8’ x 25.6”

Step2. INSTALL DRAIN VALVES COVER AND STOPPER

Make sure that outer drain plug is inserted into the outer drain cap and drain valve cover is screwed on tightly.Plug the con-

nection holes with the stoppers. (The out drain plug changes according to different size of pool.)

STOPPER Out Drain Plug A Out Drain Plug BDrain Vavle Cover

For 10’ x 6.8’ x 25.6” (3.0m x 2.07m x 65cm) , the combination is B-T1-B-T1-A.

BEAM D BEAM C

For 10’ x 6.8’ x 25.6” (3.0m x 2.07m x 65cm) , the combination is D-T1-C.

For the short side sleeve of the pool:

For the long side sleeve of the pool:

BEAM B BEAM B

(T1)T-JOINT

(T1)T-JOINT BEAM A

Step4. INSTALL L-JOINT

1. Use the connection end of the L-JOINT to connect the

adjacent horizontal tubes.

2. Use the connection end of the L-JOINT to connect the vertical leg.

(Install the vertical leg cap on the leg before.)

3. Install the screws onto the L-JOINT rmly.

TIP: If you can’t nd the hole on the horizontal tube when you install the

screw, please rotate the horizontal tube until the hole meets the screw.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Avenli 17771 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info