621854
4
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
CAMCOLBUL22N
06.12.2010 ©Velleman nv
4
o The connection cables run at the inside of the mounting bracket, and leave at the backside [3]
(default). They can be re-guided to leave via the top [4] or bottom [5] of the mounting
bracket.
o Note that the camera must be resting on top of the mounting bracket.
When the cables go through the wall:
o [B] Use the wall mounting bracket to determine and indicate the position of the mounting
holes.
o When the connection cables need to go through the wall, a hole of at least Ø10mm (max.
Ø35mm) must be foreseen at the mounting location, close to the centre of the drawn template.
Mount the mounting bracket on the wall using 4 screws (included).
Guide the connection cable into the mounting bracket and guide the connector out through the
desired hole ([3], [4] or [5]). Never exert excessive stress on the connection cable to avoid
damage. Rotate the camera to the desired angle and place the camera on the mounting bracket
making sure there is no stress on the connection cable.
Tighten hex screw [7] to secure the horizontal position and hex screw [6] for the vertical
position.
[C] Connect the connection cable with the BNC/power adaptor cable [Y]. This is only possible in
one way; do not force. Use some waterproof tape (not inc.) to make the connection completely
watertight.
Connect the video connector [1] to a monitor (not incl.).
Connect the power connector [2] to a 12VDC power supply (not incl.).
The sunshield can be mounted or dismounted by releasing the two screws on top of the camera
and sliding it towards the rear.
7. Technical specifications
pick-up element 1/3" HR colour CCD
number of pixels 752(H) x 582(V) - PAL -
resolution 520 TV lines
min. Illumination 0.1 Lux (F1.4); 0 Lux (IR on)
S/N ratio > 48dB (AGC off)
electronic shutter 1/50 to 1/100000 sec
gamma correction 0.45
white balance automatic
AGC yes
standard board lens f6.0mm/F1.4
lens angle 62°
video output 1.0Vpp composite, 75 ohms
power supply 12VDC ± 10% (regulated, use PS1205R, not incl.)
consumption 70mA (IR off), 590mA (IR on)
IP-rating IP67
IR LEDs 56
max. IR projection distance 40m
dimensions Ø115.6 x 216.4mm
weight 1350g
operating temperature 0°C to +40°C
Use this device with original accessories only. Velleman nv cannot be held responsible
in the event of damage or injury resulted from (incorrect) use of this device. For more
info concerning this product, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für AVTech - Velleman CAMCOLBUL22N wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info